Kconfig
# SPDX-License-Identifier: GPL-2.0-only
#
# ARC EMAC network device configuration
#
config NET_VENDOR_ARC
bool "ARC devices"
default y
help
If you have a network (Ethernet) card belonging to this class, say Y.
Note that the answer to this question doesn't directly affect the
kernel: saying N will just cause the configurator to skip all
the questions about ARC cards. If you say Y, you will be asked for
your specific card in the following questions.
if NET_VENDOR_ARC
config ARC_EMAC_CORE
tristate
depends on ARC || ARCH_ROCKCHIP || COMPILE_TEST
select MII
select PHYLIB
select CRC32
config ARC_EMAC
tristate "ARC EMAC support"
select ARC_EMAC_CORE
depends on OF_IRQ
depends on ARC || COMPILE_TEST
help
On some legacy ARC (Synopsys) FPGA boards such as ARCAngel4/ML50x
non-standard on-chip ethernet device ARC EMAC 10/100 is used.
Say Y here if you have such a board. If unsure, say N.
config EMAC_ROCKCHIP
tristate "Rockchip EMAC support"
select ARC_EMAC_CORE
depends on OF_IRQ && REGULATOR
depends on ARCH_ROCKCHIP || COMPILE_TEST
help
Support for Rockchip RK3036/RK3066/RK3188 EMAC ethernet controllers.
This selects Rockchip SoC glue layer support for the
emac device driver. This driver is used for RK3036/RK3066/RK3188
EMAC ethernet controller.
endif # NET_VENDOR_ARC