/*******************************************************************
*
*         Copyright (c) 2007 by Silicon Motion, Inc. (SMI)
*
*  All rights are reserved. Reproduction or in part is prohibited
*  without the written consent of the copyright owner.
*
*  swi2c.h --- SM750/SM718 DDK
*  This file contains the definitions for i2c using software
*  implementation.
*
*******************************************************************/
#ifndef _SWI2C_H_
#define _SWI2C_H_

/* Default i2c CLK and Data GPIO. These are the default i2c pins */
#define DEFAULT_I2C_SCL                     30
#define DEFAULT_I2C_SDA                     31

/*
 * This function initializes the i2c attributes and bus
 *
 * Parameters:
 *      i2cClkGPIO  - The GPIO pin to be used as i2c SCL
 *      i2cDataGPIO - The GPIO pin to be used as i2c SDA
 *
 * Return Value:
 *      -1   - Fail to initialize the i2c
 *       0   - Success
 */
long swI2CInit(
	unsigned char i2cClkGPIO,
	unsigned char i2cDataGPIO
);

/*
 *  This function reads the slave device's register
 *
 *  Parameters:
 *      deviceAddress   - i2c Slave device address which register
 *                        to be read from
 *      registerIndex   - Slave device's register to be read
 *
 *  Return Value:
 *      Register value
 */
unsigned char swI2CReadReg(
	unsigned char deviceAddress,
	unsigned char registerIndex
);

/*
 *  This function writes a value to the slave device's register
 *
 *  Parameters:
 *      deviceAddress   - i2c Slave device address which register
 *                        to be written
 *      registerIndex   - Slave device's register to be written
 *      data            - Data to be written to the register
 *
 *  Result:
 *          0   - Success
 *         -1   - Fail
 */
long swI2CWriteReg(
	unsigned char deviceAddress,
	unsigned char registerIndex,
	unsigned char data
);

/*
 *  These two functions toggle the data on the SCL and SDA I2C lines.
 *  The use of these two functions is not recommended unless it is necessary.
 */

/*
 *  This function set/reset the SCL GPIO pin
 *
 *  Parameters:
 *      value	- Bit value to set to the SCL or SDA (0 = low, 1 = high)
 */
void swI2CSCL(unsigned char value);

/*
 *  This function set/reset the SDA GPIO pin
 *
 *  Parameters:
 *      value	- Bit value to set to the SCL or SDA (0 = low, 1 = high)
 */
void swI2CSDA(unsigned char value);

#endif  /* _SWI2C_H_ */