Revision 1e37e02d528f1ca21bf460e44d04b693685d4af3 authored by Murray Stokely on 03 April 2003, 04:38:14 UTC, committed by Murray Stokely on 03 April 2003, 04:38:14 UTC
associated module so the removal goes here, rather than in drivers.conf(5). Submitted by: bmah Approved by: re@ cabal
1 parent 24cb3a1
modems
#
# $FreeBSD$
# @(#)modems 3/24/95
#
# modems -- modem configuration data base file
# see tip(1), modems(5)
#
# dial_command AT command to dial up remote
# echo_off_command AT command to turn off command echo
# escape_guard_time Shroud escape sequence with specified delay (ms)
# escape_sequence Return to command escape sequence
# hangup_command AT command to hangup modem
# hw_flow_control Enable RTS/CTS flow control between DTE/DCE
# intercharacter_delay Delay between characters sent to modem when issuing
# commands
# intercommand_delay Minimum delay between commands to modem
# init_string AT command to initialize modem before dialing out
# lock_baud Use fixed DTE / DCE bit rate
# reset_delay Delay required by modem for reset
#
sportster|st|US Robotics Sportster 14.4K:dial_command=ATDT%s\r:hangup_command=ATH\r:\
:echo_off_command=ATE0\r:reset_command=AT&F1\r:\
:init_string=AT&B1&H1&R2&C1&D2\r:\
:escape_sequence=+++:hw_flow_control:lock_baud:intercharacter_delay#50:\
:intercommand_delay#250:escape_guard_time#500:reset_delay#2000:
mt932|multitech|mt|Multitech 932:dial_command=ATDT%s\r:hangup_command=ATH\r:\
:echo_off_command=ATE0\r:reset_command=ATZ\r:\
:init_string=AT$BA0$SB38400&E1&E4&E13&E15Q0V1X4E0S0=0\r:\
:escape_sequence=+++:hw_flow_control:lock_baud:intercharacter_delay#50:\
:intercommand_delay#250:escape_guard_time#500:reset_delay#2000:
generic|Generic AT command modem (use defaults):
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...