Skip to main content

Browse the archive

Revision 207083b1da59242cbbcd1752eea359ed4760914b authored by Leonid Yegoshin on 24 November 2014, 11:54:19 UTC, committed by Markos Chandras on 17 February 2015, 15:37:27 UTC 
MIPS: kernel: r4k_switch: Add support for MIPS R6
 
Add the MIPS R6 related preprocessor definitions for save/restore
FPU related functions. We also set the appropriate ISA level
so the final return instruction "jr ra" will produce the correct
opcode on R6.

Signed-off-by: Leonid Yegoshin <Leonid.Yegoshin@imgtec.com>
Signed-off-by: Markos Chandras <markos.chandras@imgtec.com>
1 parent 9c7d576
Raw File
initramfs_data.S 
/*
  initramfs_data includes the compressed binary that is the
  filesystem used for early user space.
  Note: Older versions of "as" (prior to binutils 2.11.90.0.23
  released on 2001-07-14) dit not support .incbin.
  If you are forced to use older binutils than that then the
  following trick can be applied to create the resulting binary:


  ld -m elf_i386  --format binary --oformat elf32-i386 -r \
  -T initramfs_data.scr initramfs_data.cpio.gz -o initramfs_data.o
   ld -m elf_i386  -r -o built-in.o initramfs_data.o

  For including the .init.ramfs sections, see include/asm-generic/vmlinux.lds.

  The above example is for i386 - the parameters vary from architectures.
  Eventually look up LDFLAGS_BLOB in an older version of the
  arch/$(ARCH)/Makefile to see the flags used before .incbin was introduced.

  Using .incbin has the advantage over ld that the correct flags are set
  in the ELF header, as required by certain architectures.
*/

#include <linux/stringify.h>
#include <asm-generic/vmlinux.lds.h>

.section .init.ramfs,"a"
__irf_start:
.incbin __stringify(INITRAMFS_IMAGE)
__irf_end:
.section .init.ramfs.info,"a"
.globl VMLINUX_SYMBOL(__initramfs_size)
VMLINUX_SYMBOL(__initramfs_size):
#ifdef CONFIG_64BIT
	.quad __irf_end - __irf_start
#else
	.long __irf_end - __irf_start
#endif
back to top