Revision 257a65d79581880032e0bf0c452f4041b693664c authored by Linus Torvalds on 07 February 2011, 22:02:06 UTC, committed by Linus Torvalds on 07 February 2011, 22:02:06 UTC
* git://git.kernel.org/pub/scm/linux/kernel/git/sfrench/cifs-2.6: cifs: remove checks for ses->status == CifsExiting cifs: add check for kmalloc in parse_dacl cifs: don't send an echo request unless NegProt has been done cifs: enable signing flag in SMB header when server has it on cifs: Possible slab memory corruption while updating extended stats (repost) CIFS: Fix variable types in cifs_iovec_read/write (try #2) cifs: fix length vs. total_read confusion in cifs_demultiplex_thread
sht21
Kernel driver sht21
===================
Supported chips:
* Sensirion SHT21
Prefix: 'sht21'
Addresses scanned: none
Datasheet: Publicly available at the Sensirion website
http://www.sensirion.com/en/pdf/product_information/Datasheet-humidity-sensor-SHT21.pdf
* Sensirion SHT25
Prefix: 'sht21'
Addresses scanned: none
Datasheet: Publicly available at the Sensirion website
http://www.sensirion.com/en/pdf/product_information/Datasheet-humidity-sensor-SHT25.pdf
Author:
Urs Fleisch <urs.fleisch@sensirion.com>
Description
-----------
The SHT21 and SHT25 are humidity and temperature sensors in a DFN package of
only 3 x 3 mm footprint and 1.1 mm height. The difference between the two
devices is the higher level of precision of the SHT25 (1.8% relative humidity,
0.2 degree Celsius) compared with the SHT21 (2.0% relative humidity,
0.3 degree Celsius).
The devices communicate with the I2C protocol. All sensors are set to the same
I2C address 0x40, so an entry with I2C_BOARD_INFO("sht21", 0x40) can be used
in the board setup code.
sysfs-Interface
---------------
temp1_input - temperature input
humidity1_input - humidity input
Notes
-----
The driver uses the default resolution settings of 12 bit for humidity and 14
bit for temperature, which results in typical measurement times of 22 ms for
humidity and 66 ms for temperature. To keep self heating below 0.1 degree
Celsius, the device should not be active for more than 10% of the time,
e.g. maximum two measurements per second at the given resolution.
Different resolutions, the on-chip heater, using the CRC checksum and reading
the serial number are not supported yet.
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...