Skip to main content

Browse the archive

Revision 3b6bc354cb22b1069f88acdc7673d3476fbadfca authored by Axel Lin on 25 November 2010, 09:23:55 UTC, committed by Mark Brown on 25 November 2010, 11:07:28 UTC 
ASoC: Call snd_soc_unregister_dais instead of snd_soc_unregister_dai in sh4_soc_dai_remove
 
We call snd_soc_register_dais() in sh4_soc_dai_probe(),
thus we should call snd_soc_unregister_dais() in sh4_soc_dai_remove().

Otherwise, we got "too many arguments to function 'snd_soc_unregister_dai'"
error message.

Signed-off-by: Axel Lin <axel.lin@gmail.com>
Acked-by: Liam Girdwood <lrg@slimlogic.co.uk>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
1 parent 846172d
Raw File
initramfs_data.S 
/*
  initramfs_data includes the compressed binary that is the
  filesystem used for early user space.
  Note: Older versions of "as" (prior to binutils 2.11.90.0.23
  released on 2001-07-14) dit not support .incbin.
  If you are forced to use older binutils than that then the
  following trick can be applied to create the resulting binary:


  ld -m elf_i386  --format binary --oformat elf32-i386 -r \
  -T initramfs_data.scr initramfs_data.cpio.gz -o initramfs_data.o
   ld -m elf_i386  -r -o built-in.o initramfs_data.o

  For including the .init.ramfs sections, see include/asm-generic/vmlinux.lds.

  The above example is for i386 - the parameters vary from architectures.
  Eventually look up LDFLAGS_BLOB in an older version of the
  arch/$(ARCH)/Makefile to see the flags used before .incbin was introduced.

  Using .incbin has the advantage over ld that the correct flags are set
  in the ELF header, as required by certain architectures.
*/

#include <linux/stringify.h>

.section .init.ramfs,"a"
__irf_start:
.incbin __stringify(INITRAMFS_IMAGE)
__irf_end:
.section .init.ramfs.info,"a"
.globl __initramfs_size
__initramfs_size:
#ifdef CONFIG_64BIT
	.quad __irf_end - __irf_start
#else
	.long __irf_end - __irf_start
#endif
back to top