Revision 57be09c6e8747bf48704136d9e3f92bfb93f5725 authored by Navid Emamdoost on 02 October 2019, 03:46:07 UTC, committed by Alex Deucher on 02 October 2019, 17:58:33 UTC
In acp_hw_init there are some allocations that needs to be released in case of failure: 1- adev->acp.acp_genpd should be released if any allocation attemp for adev->acp.acp_cell, adev->acp.acp_res or i2s_pdata fails. 2- all of those allocations should be released if mfd_add_hotplug_devices or pm_genpd_add_device fail. 3- Release is needed in case of time out values expire. Reviewed-by: Christian König <christian.koenig@amd.com> Signed-off-by: Navid Emamdoost <navid.emamdoost@gmail.com> Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
1 parent 815fb4c
spi-pxa2xx-dma.c
// SPDX-License-Identifier: GPL-2.0-only
/*
* PXA2xx SPI DMA engine support.
*
* Copyright (C) 2013, Intel Corporation
* Author: Mika Westerberg <mika.westerberg@linux.intel.com>
*/
#include <linux/device.h>
#include <linux/dma-mapping.h>
#include <linux/dmaengine.h>
#include <linux/pxa2xx_ssp.h>
#include <linux/scatterlist.h>
#include <linux/sizes.h>
#include <linux/spi/spi.h>
#include <linux/spi/pxa2xx_spi.h>
#include "spi-pxa2xx.h"
static void pxa2xx_spi_dma_transfer_complete(struct driver_data *drv_data,
bool error)
{
struct spi_message *msg = drv_data->controller->cur_msg;
/*
* It is possible that one CPU is handling ROR interrupt and other
* just gets DMA completion. Calling pump_transfers() twice for the
* same transfer leads to problems thus we prevent concurrent calls
* by using ->dma_running.
*/
if (atomic_dec_and_test(&drv_data->dma_running)) {
/*
* If the other CPU is still handling the ROR interrupt we
* might not know about the error yet. So we re-check the
* ROR bit here before we clear the status register.
*/
if (!error) {
u32 status = pxa2xx_spi_read(drv_data, SSSR)
& drv_data->mask_sr;
error = status & SSSR_ROR;
}
/* Clear status & disable interrupts */
pxa2xx_spi_write(drv_data, SSCR1,
pxa2xx_spi_read(drv_data, SSCR1)
& ~drv_data->dma_cr1);
write_SSSR_CS(drv_data, drv_data->clear_sr);
if (!pxa25x_ssp_comp(drv_data))
pxa2xx_spi_write(drv_data, SSTO, 0);
if (error) {
/* In case we got an error we disable the SSP now */
pxa2xx_spi_write(drv_data, SSCR0,
pxa2xx_spi_read(drv_data, SSCR0)
& ~SSCR0_SSE);
msg->status = -EIO;
}
spi_finalize_current_transfer(drv_data->controller);
}
}
static void pxa2xx_spi_dma_callback(void *data)
{
pxa2xx_spi_dma_transfer_complete(data, false);
}
static struct dma_async_tx_descriptor *
pxa2xx_spi_dma_prepare_one(struct driver_data *drv_data,
enum dma_transfer_direction dir,
struct spi_transfer *xfer)
{
struct chip_data *chip =
spi_get_ctldata(drv_data->controller->cur_msg->spi);
enum dma_slave_buswidth width;
struct dma_slave_config cfg;
struct dma_chan *chan;
struct sg_table *sgt;
int ret;
switch (drv_data->n_bytes) {
case 1:
width = DMA_SLAVE_BUSWIDTH_1_BYTE;
break;
case 2:
width = DMA_SLAVE_BUSWIDTH_2_BYTES;
break;
default:
width = DMA_SLAVE_BUSWIDTH_4_BYTES;
break;
}
memset(&cfg, 0, sizeof(cfg));
cfg.direction = dir;
if (dir == DMA_MEM_TO_DEV) {
cfg.dst_addr = drv_data->ssdr_physical;
cfg.dst_addr_width = width;
cfg.dst_maxburst = chip->dma_burst_size;
sgt = &xfer->tx_sg;
chan = drv_data->controller->dma_tx;
} else {
cfg.src_addr = drv_data->ssdr_physical;
cfg.src_addr_width = width;
cfg.src_maxburst = chip->dma_burst_size;
sgt = &xfer->rx_sg;
chan = drv_data->controller->dma_rx;
}
ret = dmaengine_slave_config(chan, &cfg);
if (ret) {
dev_warn(&drv_data->pdev->dev, "DMA slave config failed\n");
return NULL;
}
return dmaengine_prep_slave_sg(chan, sgt->sgl, sgt->nents, dir,
DMA_PREP_INTERRUPT | DMA_CTRL_ACK);
}
irqreturn_t pxa2xx_spi_dma_transfer(struct driver_data *drv_data)
{
u32 status;
status = pxa2xx_spi_read(drv_data, SSSR) & drv_data->mask_sr;
if (status & SSSR_ROR) {
dev_err(&drv_data->pdev->dev, "FIFO overrun\n");
dmaengine_terminate_async(drv_data->controller->dma_rx);
dmaengine_terminate_async(drv_data->controller->dma_tx);
pxa2xx_spi_dma_transfer_complete(drv_data, true);
return IRQ_HANDLED;
}
return IRQ_NONE;
}
int pxa2xx_spi_dma_prepare(struct driver_data *drv_data,
struct spi_transfer *xfer)
{
struct dma_async_tx_descriptor *tx_desc, *rx_desc;
int err;
tx_desc = pxa2xx_spi_dma_prepare_one(drv_data, DMA_MEM_TO_DEV, xfer);
if (!tx_desc) {
dev_err(&drv_data->pdev->dev,
"failed to get DMA TX descriptor\n");
err = -EBUSY;
goto err_tx;
}
rx_desc = pxa2xx_spi_dma_prepare_one(drv_data, DMA_DEV_TO_MEM, xfer);
if (!rx_desc) {
dev_err(&drv_data->pdev->dev,
"failed to get DMA RX descriptor\n");
err = -EBUSY;
goto err_rx;
}
/* We are ready when RX completes */
rx_desc->callback = pxa2xx_spi_dma_callback;
rx_desc->callback_param = drv_data;
dmaengine_submit(rx_desc);
dmaengine_submit(tx_desc);
return 0;
err_rx:
dmaengine_terminate_async(drv_data->controller->dma_tx);
err_tx:
return err;
}
void pxa2xx_spi_dma_start(struct driver_data *drv_data)
{
dma_async_issue_pending(drv_data->controller->dma_rx);
dma_async_issue_pending(drv_data->controller->dma_tx);
atomic_set(&drv_data->dma_running, 1);
}
void pxa2xx_spi_dma_stop(struct driver_data *drv_data)
{
atomic_set(&drv_data->dma_running, 0);
dmaengine_terminate_sync(drv_data->controller->dma_rx);
dmaengine_terminate_sync(drv_data->controller->dma_tx);
}
int pxa2xx_spi_dma_setup(struct driver_data *drv_data)
{
struct pxa2xx_spi_controller *pdata = drv_data->controller_info;
struct device *dev = &drv_data->pdev->dev;
struct spi_controller *controller = drv_data->controller;
dma_cap_mask_t mask;
dma_cap_zero(mask);
dma_cap_set(DMA_SLAVE, mask);
controller->dma_tx = dma_request_slave_channel_compat(mask,
pdata->dma_filter, pdata->tx_param, dev, "tx");
if (!controller->dma_tx)
return -ENODEV;
controller->dma_rx = dma_request_slave_channel_compat(mask,
pdata->dma_filter, pdata->rx_param, dev, "rx");
if (!controller->dma_rx) {
dma_release_channel(controller->dma_tx);
controller->dma_tx = NULL;
return -ENODEV;
}
return 0;
}
void pxa2xx_spi_dma_release(struct driver_data *drv_data)
{
struct spi_controller *controller = drv_data->controller;
if (controller->dma_rx) {
dmaengine_terminate_sync(controller->dma_rx);
dma_release_channel(controller->dma_rx);
controller->dma_rx = NULL;
}
if (controller->dma_tx) {
dmaengine_terminate_sync(controller->dma_tx);
dma_release_channel(controller->dma_tx);
controller->dma_tx = NULL;
}
}
int pxa2xx_spi_set_dma_burst_and_threshold(struct chip_data *chip,
struct spi_device *spi,
u8 bits_per_word, u32 *burst_code,
u32 *threshold)
{
struct pxa2xx_spi_chip *chip_info = spi->controller_data;
struct driver_data *drv_data = spi_controller_get_devdata(spi->controller);
u32 dma_burst_size = drv_data->controller_info->dma_burst_size;
/*
* If the DMA burst size is given in chip_info we use that,
* otherwise we use the default. Also we use the default FIFO
* thresholds for now.
*/
*burst_code = chip_info ? chip_info->dma_burst_size : dma_burst_size;
*threshold = SSCR1_RxTresh(RX_THRESH_DFLT)
| SSCR1_TxTresh(TX_THRESH_DFLT);
return 0;
}
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...