Revision 7cccccc33aa9ab7171ca05c0b59c62912509b23e authored by Hartmut Birr on 31 October 2007, 04:57:58 UTC, committed by Mauro Carvalho Chehab on 04 November 2007, 23:41:25 UTC
Fix reported signal strength value (higher value = higher signal strength). Signed-off-by: Hartmut Birr <e9hack@googlemail.com> Signed-off-by: Oliver Endriss <o.endriss@gmx.de> Signed-off-by: Mauro Carvalho Chehab <mchehab@infradead.org>
1 parent 3de0e18
initramfs_data.S
/*
initramfs_data includes the compressed binary that is the
filesystem used for early user space.
Note: Older versions of "as" (prior to binutils 2.11.90.0.23
released on 2001-07-14) dit not support .incbin.
If you are forced to use older binutils than that then the
following trick can be applied to create the resulting binary:
ld -m elf_i386 --format binary --oformat elf32-i386 -r \
-T initramfs_data.scr initramfs_data.cpio.gz -o initramfs_data.o
ld -m elf_i386 -r -o built-in.o initramfs_data.o
initramfs_data.scr looks like this:
SECTIONS
{
.init.ramfs : { *(.data) }
}
The above example is for i386 - the parameters vary from architectures.
Eventually look up LDFLAGS_BLOB in an older version of the
arch/$(ARCH)/Makefile to see the flags used before .incbin was introduced.
Using .incbin has the advantage over ld that the correct flags are set
in the ELF header, as required by certain architectures.
*/
.section .init.ramfs,"a"
.incbin "usr/initramfs_data.cpio.gz"
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...