Revision 7e5530af11be68f3109672aed59243f82e1272f0 authored by Linus Torvalds on 03 December 2012, 00:39:00 UTC, committed by Linus Torvalds on 03 December 2012, 00:39:00 UTC
Pull networking fixes from David Miller: 1) 8139cp leaks memory in error paths, from Francois Romieu. 2) do_tcp_sendpages() cannot handle order > 0 pages, but they can certainly arrive there now, fix from Eric Dumazet. 3) Race condition and sysfs fixes in bonding from Nikolay Aleksandrov. 4) Remain-on-Channel fix in mac80211 from Felix Liao. 5) CCK rate calculation fix in iwlwifi, from Emmanuel Grumbach. * git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: 8139cp: fix coherent mapping leak in error path. tcp: fix crashes in do_tcp_sendpages() bonding: fix race condition in bonding_store_slaves_active bonding: make arp_ip_target parameter checks consistent with sysfs bonding: fix miimon and arp_interval delayed work race conditions mac80211: fix remain-on-channel (non-)cancelling iwlwifi: fix the basic CCK rates calculation
parport_cs.c
/*======================================================================
A driver for PCMCIA parallel port adapters
(specifically, for the Quatech SPP-100 EPP card: other cards will
probably require driver tweaks)
parport_cs.c 1.29 2002/10/11 06:57:41
The contents of this file are subject to the Mozilla Public
License Version 1.1 (the "License"); you may not use this file
except in compliance with the License. You may obtain a copy of
the License at http://www.mozilla.org/MPL/
Software distributed under the License is distributed on an "AS
IS" basis, WITHOUT WARRANTY OF ANY KIND, either express or
implied. See the License for the specific language governing
rights and limitations under the License.
The initial developer of the original code is David A. Hinds
<dahinds@users.sourceforge.net>. Portions created by David A. Hinds
are Copyright (C) 1999 David A. Hinds. All Rights Reserved.
Alternatively, the contents of this file may be used under the
terms of the GNU General Public License version 2 (the "GPL"), in
which case the provisions of the GPL are applicable instead of the
above. If you wish to allow the use of your version of this file
only under the terms of the GPL and not to allow others to use
your version of this file under the MPL, indicate your decision
by deleting the provisions above and replace them with the notice
and other provisions required by the GPL. If you do not delete
the provisions above, a recipient may use your version of this
file under either the MPL or the GPL.
======================================================================*/
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/init.h>
#include <linux/ptrace.h>
#include <linux/slab.h>
#include <linux/string.h>
#include <linux/timer.h>
#include <linux/ioport.h>
#include <linux/major.h>
#include <linux/interrupt.h>
#include <linux/parport.h>
#include <linux/parport_pc.h>
#include <pcmcia/cistpl.h>
#include <pcmcia/ds.h>
#include <pcmcia/cisreg.h>
#include <pcmcia/ciscode.h>
/*====================================================================*/
/* Module parameters */
MODULE_AUTHOR("David Hinds <dahinds@users.sourceforge.net>");
MODULE_DESCRIPTION("PCMCIA parallel port card driver");
MODULE_LICENSE("Dual MPL/GPL");
#define INT_MODULE_PARM(n, v) static int n = v; module_param(n, int, 0)
INT_MODULE_PARM(epp_mode, 1);
/*====================================================================*/
#define FORCE_EPP_MODE 0x08
typedef struct parport_info_t {
struct pcmcia_device *p_dev;
int ndev;
struct parport *port;
} parport_info_t;
static void parport_detach(struct pcmcia_device *p_dev);
static int parport_config(struct pcmcia_device *link);
static void parport_cs_release(struct pcmcia_device *);
static int parport_probe(struct pcmcia_device *link)
{
parport_info_t *info;
dev_dbg(&link->dev, "parport_attach()\n");
/* Create new parport device */
info = kzalloc(sizeof(*info), GFP_KERNEL);
if (!info) return -ENOMEM;
link->priv = info;
info->p_dev = link;
link->config_flags |= CONF_ENABLE_IRQ | CONF_AUTO_SET_IO;
return parport_config(link);
} /* parport_attach */
static void parport_detach(struct pcmcia_device *link)
{
dev_dbg(&link->dev, "parport_detach\n");
parport_cs_release(link);
kfree(link->priv);
} /* parport_detach */
static int parport_config_check(struct pcmcia_device *p_dev, void *priv_data)
{
p_dev->resource[0]->flags &= ~IO_DATA_PATH_WIDTH;
p_dev->resource[0]->flags |= IO_DATA_PATH_WIDTH_8;
p_dev->resource[1]->flags &= ~IO_DATA_PATH_WIDTH;
p_dev->resource[1]->flags |= IO_DATA_PATH_WIDTH_8;
return pcmcia_request_io(p_dev);
}
static int parport_config(struct pcmcia_device *link)
{
parport_info_t *info = link->priv;
struct parport *p;
int ret;
dev_dbg(&link->dev, "parport_config\n");
if (epp_mode)
link->config_index |= FORCE_EPP_MODE;
ret = pcmcia_loop_config(link, parport_config_check, NULL);
if (ret)
goto failed;
if (!link->irq)
goto failed;
ret = pcmcia_enable_device(link);
if (ret)
goto failed;
p = parport_pc_probe_port(link->resource[0]->start,
link->resource[1]->start,
link->irq, PARPORT_DMA_NONE,
&link->dev, IRQF_SHARED);
if (p == NULL) {
printk(KERN_NOTICE "parport_cs: parport_pc_probe_port() at "
"0x%3x, irq %u failed\n",
(unsigned int) link->resource[0]->start,
link->irq);
goto failed;
}
p->modes |= PARPORT_MODE_PCSPP;
if (epp_mode)
p->modes |= PARPORT_MODE_TRISTATE | PARPORT_MODE_EPP;
info->ndev = 1;
info->port = p;
return 0;
failed:
parport_cs_release(link);
return -ENODEV;
} /* parport_config */
static void parport_cs_release(struct pcmcia_device *link)
{
parport_info_t *info = link->priv;
dev_dbg(&link->dev, "parport_release\n");
if (info->ndev) {
struct parport *p = info->port;
parport_pc_unregister_port(p);
}
info->ndev = 0;
pcmcia_disable_device(link);
} /* parport_cs_release */
static const struct pcmcia_device_id parport_ids[] = {
PCMCIA_DEVICE_FUNC_ID(3),
PCMCIA_MFC_DEVICE_PROD_ID12(1,"Elan","Serial+Parallel Port: SP230",0x3beb8cf2,0xdb9e58bc),
PCMCIA_DEVICE_MANF_CARD(0x0137, 0x0003),
PCMCIA_DEVICE_NULL
};
MODULE_DEVICE_TABLE(pcmcia, parport_ids);
static struct pcmcia_driver parport_cs_driver = {
.owner = THIS_MODULE,
.name = "parport_cs",
.probe = parport_probe,
.remove = parport_detach,
.id_table = parport_ids,
};
static int __init init_parport_cs(void)
{
return pcmcia_register_driver(&parport_cs_driver);
}
static void __exit exit_parport_cs(void)
{
pcmcia_unregister_driver(&parport_cs_driver);
}
module_init(init_parport_cs);
module_exit(exit_parport_cs);
Computing file changes ...