Revision 85746e429f8e5dc8c5c0beadc0f099cb1feab93e authored by Linus Torvalds on 07 July 2011, 20:16:21 UTC, committed by Linus Torvalds on 07 July 2011, 20:16:21 UTC
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (31 commits)
  sctp: fix missing send up SCTP_SENDER_DRY_EVENT when subscribe it
  net: refine {udp|tcp|sctp}_mem limits
  vmxnet3: round down # of queues to power of two
  net: sh_eth: fix the parameter for the ETHER of SH7757
  net: sh_eth: fix cannot work half-duplex mode
  net: vlan: enable soft features regardless of underlying device
  vmxnet3: fix starving rx ring whenoc_skb kb fails
  bridge: Always flood broadcast packets
  greth: greth_set_mac_add would corrupt the MAC address.
  net: bind() fix error return on wrong address family
  natsemi: silence dma-debug warnings
  net: 8139too: Initial necessary vlan_features to support vlan
  Fix call trace when interrupts are disabled while sleeping function kzalloc is called
  qlge:Version change to v1.00.00.29
  qlge: Fix printk priority so chip fatal errors are always reported.
  qlge:Fix crash caused by mailbox execution on wedged chip.
  xfrm4: Don't call icmp_send on local error
  ipv4: Don't use ufo handling on later transformed packets
  xfrm: Remove family arg from xfrm_bundle_ok
  ipv6: Don't put artificial limit on routing table size.
  ...
2 parent s 4dd1b49 + 9491230
Raw File
IRQ.txt
What is an IRQ?

An IRQ is an interrupt request from a device.
Currently they can come in over a pin, or over a packet.
Several devices may be connected to the same pin thus
sharing an IRQ.

An IRQ number is a kernel identifier used to talk about a hardware
interrupt source.  Typically this is an index into the global irq_desc
array, but except for what linux/interrupt.h implements the details
are architecture specific.

An IRQ number is an enumeration of the possible interrupt sources on a
machine.  Typically what is enumerated is the number of input pins on
all of the interrupt controller in the system.  In the case of ISA
what is enumerated are the 16 input pins on the two i8259 interrupt
controllers.

Architectures can assign additional meaning to the IRQ numbers, and
are encouraged to in the case  where there is any manual configuration
of the hardware involved.  The ISA IRQs are a classic example of
assigning this kind of additional meaning.
back to top