Revision 85746e429f8e5dc8c5c0beadc0f099cb1feab93e authored by Linus Torvalds on 07 July 2011, 20:16:21 UTC, committed by Linus Torvalds on 07 July 2011, 20:16:21 UTC
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (31 commits) sctp: fix missing send up SCTP_SENDER_DRY_EVENT when subscribe it net: refine {udp|tcp|sctp}_mem limits vmxnet3: round down # of queues to power of two net: sh_eth: fix the parameter for the ETHER of SH7757 net: sh_eth: fix cannot work half-duplex mode net: vlan: enable soft features regardless of underlying device vmxnet3: fix starving rx ring whenoc_skb kb fails bridge: Always flood broadcast packets greth: greth_set_mac_add would corrupt the MAC address. net: bind() fix error return on wrong address family natsemi: silence dma-debug warnings net: 8139too: Initial necessary vlan_features to support vlan Fix call trace when interrupts are disabled while sleeping function kzalloc is called qlge:Version change to v1.00.00.29 qlge: Fix printk priority so chip fatal errors are always reported. qlge:Fix crash caused by mailbox execution on wedged chip. xfrm4: Don't call icmp_send on local error ipv4: Don't use ufo handling on later transformed packets xfrm: Remove family arg from xfrm_bundle_ok ipv6: Don't put artificial limit on routing table size. ...
lxfb.txt
[This file is cloned from VesaFB/aty128fb]
What is lxfb?
=================
This is a graphics framebuffer driver for AMD Geode LX based processors.
Advantages:
* No need to use AMD's VSA code (or other VESA emulation layer) in the
BIOS.
* It provides a nice large console (128 cols + 48 lines with 1024x768)
without using tiny, unreadable fonts.
* You can run XF68_FBDev on top of /dev/fb0
* Most important: boot logo :-)
Disadvantages:
* graphic mode is slower than text mode...
How to use it?
==============
Switching modes is done using lxfb.mode_option=<resolution>... boot
parameter or using `fbset' program.
See Documentation/fb/modedb.txt for more information on modedb
resolutions.
X11
===
XF68_FBDev should generally work fine, but it is non-accelerated.
Configuration
=============
You can pass kernel command line options to lxfb with lxfb.<option>.
For example, lxfb.mode_option=800x600@75.
Accepted options:
mode_option - specify the video mode. Of the form
<x>x<y>[-<bpp>][@<refresh>]
vram - size of video ram (normally auto-detected)
vt_switch - enable vt switching during suspend/resume. The vt
switch is slow, but harmless.
--
Andres Salomon <dilinger@debian.org>
Computing file changes ...