Revision 85746e429f8e5dc8c5c0beadc0f099cb1feab93e authored by Linus Torvalds on 07 July 2011, 20:16:21 UTC, committed by Linus Torvalds on 07 July 2011, 20:16:21 UTC
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (31 commits)
  sctp: fix missing send up SCTP_SENDER_DRY_EVENT when subscribe it
  net: refine {udp|tcp|sctp}_mem limits
  vmxnet3: round down # of queues to power of two
  net: sh_eth: fix the parameter for the ETHER of SH7757
  net: sh_eth: fix cannot work half-duplex mode
  net: vlan: enable soft features regardless of underlying device
  vmxnet3: fix starving rx ring whenoc_skb kb fails
  bridge: Always flood broadcast packets
  greth: greth_set_mac_add would corrupt the MAC address.
  net: bind() fix error return on wrong address family
  natsemi: silence dma-debug warnings
  net: 8139too: Initial necessary vlan_features to support vlan
  Fix call trace when interrupts are disabled while sleeping function kzalloc is called
  qlge:Version change to v1.00.00.29
  qlge: Fix printk priority so chip fatal errors are always reported.
  qlge:Fix crash caused by mailbox execution on wedged chip.
  xfrm4: Don't call icmp_send on local error
  ipv4: Don't use ufo handling on later transformed packets
  xfrm: Remove family arg from xfrm_bundle_ok
  ipv6: Don't put artificial limit on routing table size.
  ...
2 parent s 4dd1b49 + 9491230
Raw File
vt8623fb.txt

	vt8623fb - fbdev driver for graphics core in VIA VT8623 chipset
	===============================================================


Supported Hardware
==================

	VIA VT8623 [CLE266] chipset and	its graphics core
		(known as CastleRock or Unichrome)

I tested vt8623fb on VIA EPIA ML-6000


Supported Features
==================

	*  4 bpp pseudocolor modes (with 18bit palette, two variants)
	*  8 bpp pseudocolor mode (with 18bit palette)
	* 16 bpp truecolor mode (RGB 565)
	* 32 bpp truecolor mode (RGB 888)
	* text mode (activated by bpp = 0)
	* doublescan mode variant (not available in text mode)
	* panning in both directions
	* suspend/resume support
	* DPMS support

Text mode is supported even in higher resolutions, but there is limitation to
lower pixclocks (maximum about 100 MHz). This limitation is not enforced by
driver. Text mode supports 8bit wide fonts only (hardware limitation) and
16bit tall fonts (driver limitation).

There are two 4 bpp modes. First mode (selected if nonstd == 0) is mode with
packed pixels, high nibble first. Second mode (selected if nonstd == 1) is mode
with interleaved planes (1 byte interleave), MSB first. Both modes support
8bit wide fonts only (driver limitation).

Suspend/resume works on systems that initialize video card during resume and
if device is active (for example used by fbcon).


Missing Features
================
(alias TODO list)

	* secondary (not initialized by BIOS) device support
	* MMIO support
	* interlaced mode variant
	* support for fontwidths != 8 in 4 bpp modes
	* support for fontheight != 16 in text mode
	* hardware cursor
	* video overlay support
	* vsync synchronization
	* acceleration support (8514-like 2D, busmaster transfers)


Known bugs
==========

	* cursor disable in text mode doesn't work


--
Ondrej Zajicek <santiago@crfreenet.org>
back to top