Skip to main content

Browse the archive

Revision 96dcc08b0c6b730474469b10ed5eeda06e617deb authored by Sergei Shtylyov on 03 July 2007, 20:28:35 UTC, committed by Bartlomiej Zolnierkiewicz on 03 July 2007, 20:28:35 UTC 
hpt366: use correct enablebits for HPT36x
 
The HPT36x chips finally turned out to have the channel enable bits -- however,
badly implemented.  Make use of them despite it's probably only going to burden
the driver's code -- assuming both channels are always enabled by the HighPoint
BIOS anyway...

Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Acked-by: Linas Vepstas <linas@austin.ibm.com>
Cc: michal.kepien@poczta.onet.pl
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
1 parent 783353b
Raw File
Makefile 
# Makefile for the Linux sound card driver
#

obj-$(CONFIG_SOUND) += soundcore.o
obj-$(CONFIG_SOUND_PRIME) += sound_firmware.o
obj-$(CONFIG_SOUND_PRIME) += oss/
obj-$(CONFIG_DMASOUND) += oss/
obj-$(CONFIG_SND) += core/ i2c/ drivers/ isa/ pci/ ppc/ arm/ synth/ usb/ sparc/ parisc/ pcmcia/ mips/ soc/
obj-$(CONFIG_SND_AOA) += aoa/

# This one must be compilable even if sound is configured out
obj-$(CONFIG_AC97_BUS) += ac97_bus.o

ifeq ($(CONFIG_SND),y)
  obj-y += last.o
endif

soundcore-objs  := sound_core.o
back to top