Revision db0665012cc9cbc0445678e3fcce102791f721ce authored by Linus Torvalds on 28 December 2015, 02:06:31 UTC, committed by Linus Torvalds on 28 December 2015, 02:06:31 UTC
Pull ARM SoC fixes from Olof Johansson:
"A smallish set of fixes that we've been sitting on for a while now,
flushing the queue here so they go in. Summary:
A handful of fixes for OMAP, i.MX, Allwinner and Tegra:
- A clock rate and a PHY setup fix for i.MX6Q/DL
- A couple of fixes for the reduced serial bus (sunxi-rsb) on
Allwinner
- UART wakeirq fix for an OMAP4 board, timer config fixes for AM43XX.
- Suspend fix for Tegra124 Chromebooks
- Fix for missing implicit include that's different between
ARM/ARM64"
* tag 'armsoc-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
ARM: tegra: Fix suspend hang on Tegra124 Chromebooks
bus: sunxi-rsb: Fix peripheral IC mapping runtime address
bus: sunxi-rsb: Fix primary PMIC mapping hardware address
ARM: dts: Fix UART wakeirq for omap4 duovero parlor
ARM: OMAP2+: AM43xx: select ARM TWD timer
ARM: OMAP2+: am43xx: enable GENERIC_CLOCKEVENTS_BROADCAST
fsl-ifc: add missing include on ARM64
ARM: dts: imx6: Fix Ethernet PHY mode on Ventana boards
ARM: dts: imx: Fix the assigned-clock mismatch issue on imx6q/dl
bus: sunxi-rsb: unlock on error in sunxi_rsb_read()
ARM: dts: sunxi: sun6i-a31s-primo81.dts: add touchscreen axis swapping property
Kconfig
#SPI drivers
menuconfig SND_SPI
bool "SPI sound devices"
depends on SPI
default y
help
Support for sound devices connected via the SPI bus.
if SND_SPI
config SND_AT73C213
tristate "Atmel AT73C213 DAC driver"
depends on ATMEL_SSC
select SND_PCM
help
Say Y here if you want to use the Atmel AT73C213 external DAC. This
DAC can be found on Atmel development boards.
This driver requires the Atmel SSC driver for sound sink, a
peripheral found on most AT91 and AVR32 microprocessors.
To compile this driver as a module, choose M here: the module will be
called snd-at73c213.
config SND_AT73C213_TARGET_BITRATE
int "Target bitrate for AT73C213"
depends on SND_AT73C213
default "48000"
range 8000 50000
help
Sets the target bitrate for the bitrate calculator in the driver.
Limited by hardware to be between 8000 Hz and 50000 Hz.
Set to 48000 Hz by default.
endif # SND_SPI
Computing file changes ...
