Pull arm fixes for ux500 mismerge mishap from Arnd Bergmann:
 "The device tree conversion for arm/ux500 in 3.5 turns out to be
  incomplete because of a mismerge done by Linus Walleij that I failed
  to notice early enough and that Lee Jones as the original author of
  those patches did not manage to fix during the -next cycle.  While we
  originally to get a much larger set of ux500 device tree enablement
  patches merged, this did not happen in time.

  After some discussion at Linaro Connect conference this week, Lee has
  been able to do damage control and provide a series to put the broken
  platform back into usable shape for both DT and non-DT based booting.

  This series has not been part of linux-next and is based on top of the
  current state of the upstream kernel rather than an -rc, but this is
  the best we could manage given the earlier breakage."

* 'ux500/hickup' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
  ARM: ux500: Enable probing of pinctrl through Device Tree
  ARM: ux500: Add support for ab8500 regulators into the Device Tree
  ARM: ux500: Provide regulator support for SMSC911x via Device Tree
  ARM: ux500: Allow PRCMU regulator to be probed during a DT enabled boot
  ARM: ux500: Apply db8500-prcmu regulator information to db8500 Device Tree
  ARM: ux500: Only initialise STE's UIBs on boards which support them
  ARM: ux500: Disable platform setup of the ab8500 when DT is enabled
  ARM: ux500: Use correct format for dynamic IRQ assignment
  ARM: ux500: Re-enable SMSC911x platform code registration during non-DT boots
  ARM: ux500: PRCMU related configuration and layout corrections for Device Tree
  ARM: ux500: Remove DB8500 PRCMU platform registration when DT is enabled
  ARM: ux500: Disable SMSC911x platform code registration when DT is enabled
  ARM: ux500: New DT:ed u8500_init_devices for one-by-one device enablement
  ARM: ux500: New DT:ed snowball_platform_devs for one-by-one device enablement
  pinctrl-nomadik: Allow Device Tree driver probing