Skip to main content

Browse the archive

Revision fbdcf18df73758b2e187ab94678b30cd5f6ff9f9 authored by Mike Travis on 19 December 2007, 22:20:19 UTC, committed by Ingo Molnar on 19 December 2007, 22:20:19 UTC 
x86: fix show cpuinfo cpu number always zero
 
when called by setup_arch) after smp_store_cpu_info() had set it to the
correct value.

The error shows up in 'cat /proc/cpuinfo' will all cpus = 0.

Signed-off-by: Mike Travis <travis@sgi.com>
Cc: Andi Kleen <ak@suse.de>
Cc: Christoph Lameter <clameter@sgi.com>
Cc: Jack Steiner <steiner@sgi.com>
Cc: Suresh B Siddha <suresh.b.siddha@intel.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
1 parent 3d054f0
Raw File
initramfs_data.S 
/*
  initramfs_data includes the compressed binary that is the
  filesystem used for early user space.
  Note: Older versions of "as" (prior to binutils 2.11.90.0.23
  released on 2001-07-14) dit not support .incbin.
  If you are forced to use older binutils than that then the
  following trick can be applied to create the resulting binary:


  ld -m elf_i386  --format binary --oformat elf32-i386 -r \
  -T initramfs_data.scr initramfs_data.cpio.gz -o initramfs_data.o
   ld -m elf_i386  -r -o built-in.o initramfs_data.o

  initramfs_data.scr looks like this:
SECTIONS
{
       .init.ramfs : { *(.data) }
}

  The above example is for i386 - the parameters vary from architectures.
  Eventually look up LDFLAGS_BLOB in an older version of the
  arch/$(ARCH)/Makefile to see the flags used before .incbin was introduced.

  Using .incbin has the advantage over ld that the correct flags are set
  in the ELF header, as required by certain architectures.
*/

.section .init.ramfs,"a"
.incbin "usr/initramfs_data.cpio.gz"
back to top