https://github.com/torvalds/linux
Revision fce7fc79c8f7188dfc5eafa1b937bcc3c5a4c2f5 authored by Linus Torvalds on 26 March 2014, 00:43:34 UTC, committed by Linus Torvalds on 26 March 2014, 00:43:34 UTC
The previous commit removed the register_filesystem() call and the associated error handling, but left the label for the error path that no longer exists. Remove that too. Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
1 parent d6f2589
Tip revision: fce7fc79c8f7188dfc5eafa1b937bcc3c5a4c2f5 authored by Linus Torvalds on 26 March 2014, 00:43:34 UTC
fs: remove now stale label in anon_inode_init()
fs: remove now stale label in anon_inode_init()
Tip revision: fce7fc7
Kconfig
#
# Controller Area Network (CAN) network layer core configuration
#
menuconfig CAN
depends on NET
tristate "CAN bus subsystem support"
---help---
Controller Area Network (CAN) is a slow (up to 1Mbit/s) serial
communications protocol which was developed by Bosch in
1991, mainly for automotive, but now widely used in marine
(NMEA2000), industrial, and medical applications.
More information on the CAN network protocol family PF_CAN
is contained in <Documentation/networking/can.txt>.
If you want CAN support you should say Y here and also to the
specific driver for your controller(s) below.
if CAN
config CAN_RAW
tristate "Raw CAN Protocol (raw access with CAN-ID filtering)"
default y
---help---
The raw CAN protocol option offers access to the CAN bus via
the BSD socket API. You probably want to use the raw socket in
most cases where no higher level protocol is being used. The raw
socket has several filter options e.g. ID masking / error frames.
To receive/send raw CAN messages, use AF_CAN with protocol CAN_RAW.
config CAN_BCM
tristate "Broadcast Manager CAN Protocol (with content filtering)"
default y
---help---
The Broadcast Manager offers content filtering, timeout monitoring,
sending of RTR frames, and cyclic CAN messages without permanent user
interaction. The BCM can be 'programmed' via the BSD socket API and
informs you on demand e.g. only on content updates / timeouts.
You probably want to use the bcm socket in most cases where cyclic
CAN messages are used on the bus (e.g. in automotive environments).
To use the Broadcast Manager, use AF_CAN with protocol CAN_BCM.
config CAN_GW
tristate "CAN Gateway/Router (with netlink configuration)"
default y
---help---
The CAN Gateway/Router is used to route (and modify) CAN frames.
It is based on the PF_CAN core infrastructure for msg filtering and
msg sending and can optionally modify routed CAN frames on the fly.
CAN frames can be routed between CAN network interfaces (one hop).
They can be modified with AND/OR/XOR/SET operations as configured
by the netlink configuration interface known e.g. from iptables.
source "drivers/net/can/Kconfig"
endif
Computing file changes ...