swh:1:snp:173f8deb0c56c557784b4fd217e7608ac6197844
Tip revision: 2f4ba45a75d6383b4a1201169a808ffea416ffa0 authored by Linus Torvalds on 13 September 2005, 03:12:09 UTC
Linux 2.6.14-rc1
Linux 2.6.14-rc1
Tip revision: 2f4ba45
Kconfig.debug
menu "Kernel hacking"
source "lib/Kconfig.debug"
config EARLY_PRINTK
bool "Early printk"
depends on EMBEDDED && DEBUG_KERNEL
default n
help
Write kernel log output directly into the VGA buffer or to a serial
port.
This is useful for kernel debugging when your machine crashes very
early before the console code is initialized. For normal operation
it is not recommended because it looks ugly and doesn't cooperate
with klogd/syslogd or the X server. You should normally N here,
unless you want to debug such a crash.
config DEBUG_STACKOVERFLOW
bool "Check for stack overflows"
depends on DEBUG_KERNEL
config DEBUG_PAGEALLOC
bool "Page alloc debugging"
depends on DEBUG_KERNEL
help
Unmap pages from the kernel linear mapping after free_pages().
This results in a large slowdown, but helps to find certain types
of memory corruptions.
config GDBSTUB
bool "Remote GDB kernel debugging"
depends on DEBUG_KERNEL
select DEBUG_INFO
select FRAME_POINTER
help
If you say Y here, it will be possible to remotely debug the kernel
using gdb. This enlarges your kernel ELF image disk size by several
megabytes and requires a machine with more than 16 MB, better 32 MB
RAM to avoid excessive linking time. This is only useful for kernel
hackers. If unsure, say N.
choice
prompt "GDB stub port"
default GDBSTUB_UART1
depends on GDBSTUB
help
Select the on-CPU port used for GDB-stub
config GDBSTUB_UART0
bool "/dev/ttyS0"
config GDBSTUB_UART1
bool "/dev/ttyS1"
endchoice
config GDBSTUB_IMMEDIATE
bool "Break into GDB stub immediately"
depends on GDBSTUB
help
If you say Y here, GDB stub will break into the program as soon as
possible, leaving the program counter at the beginning of
start_kernel() in init/main.c.
config GDB_CONSOLE
bool "Console output to GDB"
depends on GDBSTUB
help
If you are using GDB for remote debugging over a serial port and
would like kernel messages to be formatted into GDB $O packets so
that GDB prints them as program output, say 'Y'.
endmenu