swh:1:snp:173f8deb0c56c557784b4fd217e7608ac6197844
Tip revision: e42617b825f8073569da76dc4510bfa019b1c35a authored by Linus Torvalds on 08 December 2019, 22:57:55 UTC
Linux 5.5-rc1
Linux 5.5-rc1
Tip revision: e42617b
xen-asm.S
/* SPDX-License-Identifier: GPL-2.0 */
/*
* Asm versions of Xen pv-ops, suitable for direct use.
*
* We only bother with direct forms (ie, vcpu in percpu data) of the
* operations here; the indirect forms are better handled in C.
*/
#include <asm/asm-offsets.h>
#include <asm/percpu.h>
#include <asm/processor-flags.h>
#include <asm/frame.h>
#include <asm/asm.h>
#include <linux/linkage.h>
/*
* Enable events. This clears the event mask and tests the pending
* event status with one and operation. If there are pending events,
* then enter the hypervisor to get them handled.
*/
SYM_FUNC_START(xen_irq_enable_direct)
FRAME_BEGIN
/* Unmask events */
movb $0, PER_CPU_VAR(xen_vcpu_info) + XEN_vcpu_info_mask
/*
* Preempt here doesn't matter because that will deal with any
* pending interrupts. The pending check may end up being run
* on the wrong CPU, but that doesn't hurt.
*/
/* Test for pending */
testb $0xff, PER_CPU_VAR(xen_vcpu_info) + XEN_vcpu_info_pending
jz 1f
call check_events
1:
FRAME_END
ret
SYM_FUNC_END(xen_irq_enable_direct)
/*
* Disabling events is simply a matter of making the event mask
* non-zero.
*/
SYM_FUNC_START(xen_irq_disable_direct)
movb $1, PER_CPU_VAR(xen_vcpu_info) + XEN_vcpu_info_mask
ret
SYM_FUNC_END(xen_irq_disable_direct)
/*
* (xen_)save_fl is used to get the current interrupt enable status.
* Callers expect the status to be in X86_EFLAGS_IF, and other bits
* may be set in the return value. We take advantage of this by
* making sure that X86_EFLAGS_IF has the right value (and other bits
* in that byte are 0), but other bits in the return value are
* undefined. We need to toggle the state of the bit, because Xen and
* x86 use opposite senses (mask vs enable).
*/
SYM_FUNC_START(xen_save_fl_direct)
testb $0xff, PER_CPU_VAR(xen_vcpu_info) + XEN_vcpu_info_mask
setz %ah
addb %ah, %ah
ret
SYM_FUNC_END(xen_save_fl_direct)
/*
* In principle the caller should be passing us a value return from
* xen_save_fl_direct, but for robustness sake we test only the
* X86_EFLAGS_IF flag rather than the whole byte. After setting the
* interrupt mask state, it checks for unmasked pending events and
* enters the hypervisor to get them delivered if so.
*/
SYM_FUNC_START(xen_restore_fl_direct)
FRAME_BEGIN
#ifdef CONFIG_X86_64
testw $X86_EFLAGS_IF, %di
#else
testb $X86_EFLAGS_IF>>8, %ah
#endif
setz PER_CPU_VAR(xen_vcpu_info) + XEN_vcpu_info_mask
/*
* Preempt here doesn't matter because that will deal with any
* pending interrupts. The pending check may end up being run
* on the wrong CPU, but that doesn't hurt.
*/
/* check for unmasked and pending */
cmpw $0x0001, PER_CPU_VAR(xen_vcpu_info) + XEN_vcpu_info_pending
jnz 1f
call check_events
1:
FRAME_END
ret
SYM_FUNC_END(xen_restore_fl_direct)
/*
* Force an event check by making a hypercall, but preserve regs
* before making the call.
*/
SYM_FUNC_START(check_events)
FRAME_BEGIN
#ifdef CONFIG_X86_32
push %eax
push %ecx
push %edx
call xen_force_evtchn_callback
pop %edx
pop %ecx
pop %eax
#else
push %rax
push %rcx
push %rdx
push %rsi
push %rdi
push %r8
push %r9
push %r10
push %r11
call xen_force_evtchn_callback
pop %r11
pop %r10
pop %r9
pop %r8
pop %rdi
pop %rsi
pop %rdx
pop %rcx
pop %rax
#endif
FRAME_END
ret
SYM_FUNC_END(check_events)
SYM_FUNC_START(xen_read_cr2)
FRAME_BEGIN
_ASM_MOV PER_CPU_VAR(xen_vcpu), %_ASM_AX
_ASM_MOV XEN_vcpu_info_arch_cr2(%_ASM_AX), %_ASM_AX
FRAME_END
ret
SYM_FUNC_END(xen_read_cr2);
SYM_FUNC_START(xen_read_cr2_direct)
FRAME_BEGIN
_ASM_MOV PER_CPU_VAR(xen_vcpu_info) + XEN_vcpu_info_arch_cr2, %_ASM_AX
FRAME_END
ret
SYM_FUNC_END(xen_read_cr2_direct);