swh:1:snp:49cd9498d6cccc5e78252c27dcb645bcf7bf0c91
Tip revision: af2d861d4cd2a4da5137f795ee3509e6f944a25b authored by Linus Torvalds on 24 April 2022, 21:51:22 UTC
Linux 5.18-rc4
Linux 5.18-rc4
Tip revision: af2d861
omap_ssi.h
/* SPDX-License-Identifier: GPL-2.0-only */
/* OMAP SSI internal interface.
*
* Copyright (C) 2010 Nokia Corporation. All rights reserved.
* Copyright (C) 2013 Sebastian Reichel
*
* Contact: Carlos Chinea <carlos.chinea@nokia.com>
*/
#ifndef __LINUX_HSI_OMAP_SSI_H__
#define __LINUX_HSI_OMAP_SSI_H__
#include <linux/device.h>
#include <linux/module.h>
#include <linux/platform_device.h>
#include <linux/hsi/hsi.h>
#include <linux/gpio/consumer.h>
#include <linux/interrupt.h>
#include <linux/io.h>
#define SSI_MAX_CHANNELS 8
#define SSI_MAX_GDD_LCH 8
#define SSI_BYTES_TO_FRAMES(x) ((((x) - 1) >> 2) + 1)
#define SSI_WAKE_EN 0
/**
* struct omap_ssm_ctx - OMAP synchronous serial module (TX/RX) context
* @mode: Bit transmission mode
* @channels: Number of channels
* @framesize: Frame size in bits
* @timeout: RX frame timeout
* @divisor: TX divider
* @arb_mode: Arbitration mode for TX frame (Round robin, priority)
*/
struct omap_ssm_ctx {
u32 mode;
u32 channels;
u32 frame_size;
union {
u32 timeout; /* Rx Only */
struct {
u32 arb_mode;
u32 divisor;
}; /* Tx only */
};
};
/**
* struct omap_ssi_port - OMAP SSI port data
* @dev: device associated to the port (HSI port)
* @pdev: platform device associated to the port
* @sst_dma: SSI transmitter physical base address
* @ssr_dma: SSI receiver physical base address
* @sst_base: SSI transmitter base address
* @ssr_base: SSI receiver base address
* @wk_lock: spin lock to serialize access to the wake lines
* @lock: Spin lock to serialize access to the SSI port
* @channels: Current number of channels configured (1,2,4 or 8)
* @txqueue: TX message queues
* @rxqueue: RX message queues
* @brkqueue: Queue of incoming HWBREAK requests (FRAME mode)
* @errqueue: Queue for failed messages
* @errqueue_work: Delayed Work for failed messages
* @irq: IRQ number
* @wake_irq: IRQ number for incoming wake line (-1 if none)
* @wake_gpio: GPIO number for incoming wake line (-1 if none)
* @flags: flags to keep track of states
* @wk_refcount: Reference count for output wake line
* @work: worker for starting TX
* @sys_mpu_enable: Context for the interrupt enable register for irq 0
* @sst: Context for the synchronous serial transmitter
* @ssr: Context for the synchronous serial receiver
*/
struct omap_ssi_port {
struct device *dev;
struct device *pdev;
dma_addr_t sst_dma;
dma_addr_t ssr_dma;
void __iomem *sst_base;
void __iomem *ssr_base;
spinlock_t wk_lock;
spinlock_t lock;
unsigned int channels;
struct list_head txqueue[SSI_MAX_CHANNELS];
struct list_head rxqueue[SSI_MAX_CHANNELS];
struct list_head brkqueue;
struct list_head errqueue;
struct delayed_work errqueue_work;
unsigned int irq;
int wake_irq;
struct gpio_desc *wake_gpio;
bool wktest:1; /* FIXME: HACK to be removed */
unsigned long flags;
unsigned int wk_refcount;
struct work_struct work;
/* OMAP SSI port context */
u32 sys_mpu_enable; /* We use only one irq */
struct omap_ssm_ctx sst;
struct omap_ssm_ctx ssr;
u32 loss_count;
u32 port_id;
#ifdef CONFIG_DEBUG_FS
struct dentry *dir;
#endif
};
/**
* struct gdd_trn - GDD transaction data
* @msg: Pointer to the HSI message being served
* @sg: Pointer to the current sg entry being served
*/
struct gdd_trn {
struct hsi_msg *msg;
struct scatterlist *sg;
};
/**
* struct omap_ssi_controller - OMAP SSI controller data
* @dev: device associated to the controller (HSI controller)
* @sys: SSI I/O base address
* @gdd: GDD I/O base address
* @fck: SSI functional clock
* @gdd_irq: IRQ line for GDD
* @gdd_tasklet: bottom half for DMA transfers
* @gdd_trn: Array of GDD transaction data for ongoing GDD transfers
* @lock: lock to serialize access to GDD
* @fck_nb: DVFS notfifier block
* @fck_rate: clock rate
* @loss_count: To follow if we need to restore context or not
* @max_speed: Maximum TX speed (Kb/s) set by the clients.
* @gdd_gcr: SSI GDD saved context
* @get_loss: Pointer to omap_pm_get_dev_context_loss_count, if any
* @port: Array of pointers of the ports of the controller
* @dir: Debugfs SSI root directory
*/
struct omap_ssi_controller {
struct device *dev;
void __iomem *sys;
void __iomem *gdd;
struct clk *fck;
unsigned int gdd_irq;
struct tasklet_struct gdd_tasklet;
struct gdd_trn gdd_trn[SSI_MAX_GDD_LCH];
spinlock_t lock;
struct notifier_block fck_nb;
unsigned long fck_rate;
u32 loss_count;
u32 max_speed;
/* OMAP SSI Controller context */
u32 gdd_gcr;
int (*get_loss)(struct device *dev);
struct omap_ssi_port **port;
#ifdef CONFIG_DEBUG_FS
struct dentry *dir;
#endif
};
void omap_ssi_port_update_fclk(struct hsi_controller *ssi,
struct omap_ssi_port *omap_port);
extern struct platform_driver ssi_port_pdriver;
#endif /* __LINUX_HSI_OMAP_SSI_H__ */