swh:1:snp:77163734605b0ec556b01d897b7bb4a7e30d46b6
Tip revision: b90cb1053190353cc30f0fef0ef1f378ccc063c5 authored by Linus Torvalds on 28 August 2022, 22:05:29 UTC
Linux 6.0-rc3
Linux 6.0-rc3
Tip revision: b90cb10
pci-test-function.rst
.. SPDX-License-Identifier: GPL-2.0
=================
PCI Test Function
=================
:Author: Kishon Vijay Abraham I <kishon@ti.com>
Traditionally PCI RC has always been validated by using standard
PCI cards like ethernet PCI cards or USB PCI cards or SATA PCI cards.
However with the addition of EP-core in linux kernel, it is possible
to configure a PCI controller that can operate in EP mode to work as
a test device.
The PCI endpoint test device is a virtual device (defined in software)
used to test the endpoint functionality and serve as a sample driver
for other PCI endpoint devices (to use the EP framework).
The PCI endpoint test device has the following registers:
1) PCI_ENDPOINT_TEST_MAGIC
2) PCI_ENDPOINT_TEST_COMMAND
3) PCI_ENDPOINT_TEST_STATUS
4) PCI_ENDPOINT_TEST_SRC_ADDR
5) PCI_ENDPOINT_TEST_DST_ADDR
6) PCI_ENDPOINT_TEST_SIZE
7) PCI_ENDPOINT_TEST_CHECKSUM
8) PCI_ENDPOINT_TEST_IRQ_TYPE
9) PCI_ENDPOINT_TEST_IRQ_NUMBER
* PCI_ENDPOINT_TEST_MAGIC
This register will be used to test BAR0. A known pattern will be written
and read back from MAGIC register to verify BAR0.
* PCI_ENDPOINT_TEST_COMMAND
This register will be used by the host driver to indicate the function
that the endpoint device must perform.
======== ================================================================
Bitfield Description
======== ================================================================
Bit 0 raise legacy IRQ
Bit 1 raise MSI IRQ
Bit 2 raise MSI-X IRQ
Bit 3 read command (read data from RC buffer)
Bit 4 write command (write data to RC buffer)
Bit 5 copy command (copy data from one RC buffer to another RC buffer)
======== ================================================================
* PCI_ENDPOINT_TEST_STATUS
This register reflects the status of the PCI endpoint device.
======== ==============================
Bitfield Description
======== ==============================
Bit 0 read success
Bit 1 read fail
Bit 2 write success
Bit 3 write fail
Bit 4 copy success
Bit 5 copy fail
Bit 6 IRQ raised
Bit 7 source address is invalid
Bit 8 destination address is invalid
======== ==============================
* PCI_ENDPOINT_TEST_SRC_ADDR
This register contains the source address (RC buffer address) for the
COPY/READ command.
* PCI_ENDPOINT_TEST_DST_ADDR
This register contains the destination address (RC buffer address) for
the COPY/WRITE command.
* PCI_ENDPOINT_TEST_IRQ_TYPE
This register contains the interrupt type (Legacy/MSI) triggered
for the READ/WRITE/COPY and raise IRQ (Legacy/MSI) commands.
Possible types:
====== ==
Legacy 0
MSI 1
MSI-X 2
====== ==
* PCI_ENDPOINT_TEST_IRQ_NUMBER
This register contains the triggered ID interrupt.
Admissible values:
====== ===========
Legacy 0
MSI [1 .. 32]
MSI-X [1 .. 2048]
====== ===========