swh:1:snp:c2847dfd741eae21606027cf29250d1ebcd63fb4
Tip revision: d1abaeb3be7b5fa6d7a1fbbd2e14e3310005c4c1 authored by Linus Torvalds on 18 August 2019, 21:31:08 UTC
Linux 5.3-rc5
Linux 5.3-rc5
Tip revision: d1abaeb
toshsd.h
/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* Toshiba PCI Secure Digital Host Controller Interface driver
*
* Copyright (C) 2014 Ondrej Zary
* Copyright (C) 2007 Richard Betts, All Rights Reserved.
*
* Based on asic3_mmc.c Copyright (c) 2005 SDG Systems, LLC
*/
#define HCLK 33000000 /* 33 MHz (PCI clock) */
#define SD_PCICFG_CLKSTOP 0x40 /* 0x1f = clock controller, 0 = stop */
#define SD_PCICFG_GATEDCLK 0x41 /* Gated clock */
#define SD_PCICFG_CLKMODE 0x42 /* Control clock of SD controller */
#define SD_PCICFG_PINSTATUS 0x44 /* R/O: read status of SD pins */
#define SD_PCICFG_POWER1 0x48
#define SD_PCICFG_POWER2 0x49
#define SD_PCICFG_POWER3 0x4a
#define SD_PCICFG_CARDDETECT 0x4c
#define SD_PCICFG_SLOTS 0x50 /* R/O: define support slot number */
#define SD_PCICFG_EXTGATECLK1 0xf0 /* Could be used for gated clock */
#define SD_PCICFG_EXTGATECLK2 0xf1 /* Could be used for gated clock */
#define SD_PCICFG_EXTGATECLK3 0xf9 /* Bit 1: double buffer/single buffer */
#define SD_PCICFG_SDLED_ENABLE1 0xfa
#define SD_PCICFG_SDLED_ENABLE2 0xfe
#define SD_PCICFG_CLKMODE_DIV_DISABLE BIT(0)
#define SD_PCICFG_CLKSTOP_ENABLE_ALL 0x1f
#define SD_PCICFG_LED_ENABLE1_START 0x12
#define SD_PCICFG_LED_ENABLE2_START 0x80
#define SD_PCICFG_PWR1_33V 0x08 /* Set for 3.3 volts */
#define SD_PCICFG_PWR1_OFF 0x00 /* Turn off power */
#define SD_PCICFG_PWR2_AUTO 0x02
#define SD_CMD 0x00 /* also for SDIO */
#define SD_ARG0 0x04 /* also for SDIO */
#define SD_ARG1 0x06 /* also for SDIO */
#define SD_STOPINTERNAL 0x08
#define SD_BLOCKCOUNT 0x0a /* also for SDIO */
#define SD_RESPONSE0 0x0c /* also for SDIO */
#define SD_RESPONSE1 0x0e /* also for SDIO */
#define SD_RESPONSE2 0x10 /* also for SDIO */
#define SD_RESPONSE3 0x12 /* also for SDIO */
#define SD_RESPONSE4 0x14 /* also for SDIO */
#define SD_RESPONSE5 0x16 /* also for SDIO */
#define SD_RESPONSE6 0x18 /* also for SDIO */
#define SD_RESPONSE7 0x1a /* also for SDIO */
#define SD_CARDSTATUS 0x1c /* also for SDIO */
#define SD_BUFFERCTRL 0x1e /* also for SDIO */
#define SD_INTMASKCARD 0x20 /* also for SDIO */
#define SD_INTMASKBUFFER 0x22 /* also for SDIO */
#define SD_CARDCLOCKCTRL 0x24
#define SD_CARDXFERDATALEN 0x26 /* also for SDIO */
#define SD_CARDOPTIONSETUP 0x28 /* also for SDIO */
#define SD_ERRORSTATUS0 0x2c /* also for SDIO */
#define SD_ERRORSTATUS1 0x2e /* also for SDIO */
#define SD_DATAPORT 0x30 /* also for SDIO */
#define SD_TRANSACTIONCTRL 0x34 /* also for SDIO */
#define SD_SOFTWARERESET 0xe0 /* also for SDIO */
/* registers above marked "also for SDIO" and all SDIO registers below can be
* accessed at SDIO_BASE + reg address */
#define SDIO_BASE 0x100
#define SDIO_CARDPORTSEL 0x02
#define SDIO_CARDINTCTRL 0x36
#define SDIO_CLOCKNWAITCTRL 0x38
#define SDIO_HOSTINFORMATION 0x3a
#define SDIO_ERRORCTRL 0x3c
#define SDIO_LEDCTRL 0x3e
#define SD_TRANSCTL_SET BIT(8)
#define SD_CARDCLK_DIV_DISABLE BIT(15)
#define SD_CARDCLK_ENABLE_CLOCK BIT(8)
#define SD_CARDCLK_CLK_DIV_512 BIT(7)
#define SD_CARDCLK_CLK_DIV_256 BIT(6)
#define SD_CARDCLK_CLK_DIV_128 BIT(5)
#define SD_CARDCLK_CLK_DIV_64 BIT(4)
#define SD_CARDCLK_CLK_DIV_32 BIT(3)
#define SD_CARDCLK_CLK_DIV_16 BIT(2)
#define SD_CARDCLK_CLK_DIV_8 BIT(1)
#define SD_CARDCLK_CLK_DIV_4 BIT(0)
#define SD_CARDCLK_CLK_DIV_2 0
#define SD_CARDOPT_REQUIRED 0x000e
#define SD_CARDOPT_DATA_RESP_TIMEOUT(x) (((x) & 0x0f) << 4) /* 4 bits */
#define SD_CARDOPT_C2_MODULE_ABSENT BIT(14)
#define SD_CARDOPT_DATA_XFR_WIDTH_1 (1 << 15)
#define SD_CARDOPT_DATA_XFR_WIDTH_4 (0 << 15)
#define SD_CMD_TYPE_CMD (0 << 6)
#define SD_CMD_TYPE_ACMD (1 << 6)
#define SD_CMD_TYPE_AUTHEN (2 << 6)
#define SD_CMD_RESP_TYPE_NONE (3 << 8)
#define SD_CMD_RESP_TYPE_EXT_R1 (4 << 8)
#define SD_CMD_RESP_TYPE_EXT_R1B (5 << 8)
#define SD_CMD_RESP_TYPE_EXT_R2 (6 << 8)
#define SD_CMD_RESP_TYPE_EXT_R3 (7 << 8)
#define SD_CMD_RESP_TYPE_EXT_R6 (4 << 8)
#define SD_CMD_RESP_TYPE_EXT_R7 (4 << 8)
#define SD_CMD_DATA_PRESENT BIT(11)
#define SD_CMD_TRANSFER_READ BIT(12)
#define SD_CMD_MULTI_BLOCK BIT(13)
#define SD_CMD_SECURITY_CMD BIT(14)
#define SD_STOPINT_ISSUE_CMD12 BIT(0)
#define SD_STOPINT_AUTO_ISSUE_CMD12 BIT(8)
#define SD_CARD_RESP_END BIT(0)
#define SD_CARD_RW_END BIT(2)
#define SD_CARD_CARD_REMOVED_0 BIT(3)
#define SD_CARD_CARD_INSERTED_0 BIT(4)
#define SD_CARD_PRESENT_0 BIT(5)
#define SD_CARD_UNK6 BIT(6)
#define SD_CARD_WRITE_PROTECT BIT(7)
#define SD_CARD_CARD_REMOVED_3 BIT(8)
#define SD_CARD_CARD_INSERTED_3 BIT(9)
#define SD_CARD_PRESENT_3 BIT(10)
#define SD_BUF_CMD_INDEX_ERR BIT(16)
#define SD_BUF_CRC_ERR BIT(17)
#define SD_BUF_STOP_BIT_END_ERR BIT(18)
#define SD_BUF_DATA_TIMEOUT BIT(19)
#define SD_BUF_OVERFLOW BIT(20)
#define SD_BUF_UNDERFLOW BIT(21)
#define SD_BUF_CMD_TIMEOUT BIT(22)
#define SD_BUF_UNK7 BIT(23)
#define SD_BUF_READ_ENABLE BIT(24)
#define SD_BUF_WRITE_ENABLE BIT(25)
#define SD_BUF_ILLEGAL_FUNCTION BIT(29)
#define SD_BUF_CMD_BUSY BIT(30)
#define SD_BUF_ILLEGAL_ACCESS BIT(31)
#define SD_ERR0_RESP_CMD_ERR BIT(0)
#define SD_ERR0_RESP_NON_CMD12_END_BIT_ERR BIT(2)
#define SD_ERR0_RESP_CMD12_END_BIT_ERR BIT(3)
#define SD_ERR0_READ_DATA_END_BIT_ERR BIT(4)
#define SD_ERR0_WRITE_CRC_STATUS_END_BIT_ERR BIT(5)
#define SD_ERR0_RESP_NON_CMD12_CRC_ERR BIT(8)
#define SD_ERR0_RESP_CMD12_CRC_ERR BIT(9)
#define SD_ERR0_READ_DATA_CRC_ERR BIT(10)
#define SD_ERR0_WRITE_CMD_CRC_ERR BIT(11)
#define SD_ERR1_NO_CMD_RESP BIT(16)
#define SD_ERR1_TIMEOUT_READ_DATA BIT(20)
#define SD_ERR1_TIMEOUT_CRS_STATUS BIT(21)
#define SD_ERR1_TIMEOUT_CRC_BUSY BIT(22)
#define IRQ_DONT_CARE_BITS (SD_CARD_PRESENT_3 \
| SD_CARD_WRITE_PROTECT \
| SD_CARD_UNK6 \
| SD_CARD_PRESENT_0 \
| SD_BUF_UNK7 \
| SD_BUF_CMD_BUSY)
struct toshsd_host {
struct pci_dev *pdev;
struct mmc_host *mmc;
spinlock_t lock;
struct mmc_request *mrq;/* Current request */
struct mmc_command *cmd;/* Current command */
struct mmc_data *data; /* Current data request */
struct sg_mapping_iter sg_miter; /* for PIO */
void __iomem *ioaddr; /* mapped address */
};