swh:1:snp:c2847dfd741eae21606027cf29250d1ebcd63fb4
Tip revision: 3c2993b8c6143d8a5793746a54eba8f86f95240f authored by Linus Torvalds on 04 June 2017, 23:47:43 UTC
Linux 4.12-rc4
Linux 4.12-rc4
Tip revision: 3c2993b
setup-irq.c
/*
* drivers/pci/setup-irq.c
*
* Extruded from code written by
* Dave Rusling (david.rusling@reo.mts.dec.com)
* David Mosberger (davidm@cs.arizona.edu)
* David Miller (davem@redhat.com)
*
* Support routines for initializing a PCI subsystem.
*/
#include <linux/kernel.h>
#include <linux/pci.h>
#include <linux/errno.h>
#include <linux/ioport.h>
#include <linux/cache.h>
void __weak pcibios_update_irq(struct pci_dev *dev, int irq)
{
dev_dbg(&dev->dev, "assigning IRQ %02d\n", irq);
pci_write_config_byte(dev, PCI_INTERRUPT_LINE, irq);
}
static void pdev_fixup_irq(struct pci_dev *dev,
u8 (*swizzle)(struct pci_dev *, u8 *),
int (*map_irq)(const struct pci_dev *, u8, u8))
{
u8 pin, slot;
int irq = 0;
/* If this device is not on the primary bus, we need to figure out
which interrupt pin it will come in on. We know which slot it
will come in on 'cos that slot is where the bridge is. Each
time the interrupt line passes through a PCI-PCI bridge we must
apply the swizzle function. */
pci_read_config_byte(dev, PCI_INTERRUPT_PIN, &pin);
/* Cope with illegal. */
if (pin > 4)
pin = 1;
if (pin != 0) {
/* Follow the chain of bridges, swizzling as we go. */
slot = (*swizzle)(dev, &pin);
irq = (*map_irq)(dev, slot, pin);
if (irq == -1)
irq = 0;
}
dev->irq = irq;
dev_dbg(&dev->dev, "fixup irq: got %d\n", dev->irq);
/* Always tell the device, so the driver knows what is
the real IRQ to use; the device does not use it. */
pcibios_update_irq(dev, irq);
}
void pci_fixup_irqs(u8 (*swizzle)(struct pci_dev *, u8 *),
int (*map_irq)(const struct pci_dev *, u8, u8))
{
struct pci_dev *dev = NULL;
for_each_pci_dev(dev)
pdev_fixup_irq(dev, swizzle, map_irq);
}
EXPORT_SYMBOL_GPL(pci_fixup_irqs);