swh:1:snp:c3bf2749e3476071fa748f67b0ffa2fdc5fe49d9
Tip revision: 88026842b0a760145aa71d69e74fbc9ec118ca44 authored by Linus Torvalds on 03 January 2006, 03:21:10 UTC
Linux v2.6.15
Linux v2.6.15
Tip revision: 8802684
netdevices.txt
Network Devices, the Kernel, and You!
Introduction
============
The following is a random collection of documentation regarding
network devices.
struct net_device allocation rules
==================================
Network device structures need to persist even after module is unloaded and
must be allocated with kmalloc. If device has registered successfully,
it will be freed on last use by free_netdev. This is required to handle the
pathologic case cleanly (example: rmmod mydriver </sys/class/net/myeth/mtu )
There are routines in net_init.c to handle the common cases of
alloc_etherdev, alloc_netdev. These reserve extra space for driver
private data which gets freed when the network device is freed. If
separately allocated data is attached to the network device
(dev->priv) then it is up to the module exit handler to free that.
struct net_device synchronization rules
=======================================
dev->open:
Synchronization: rtnl_lock() semaphore.
Context: process
dev->stop:
Synchronization: rtnl_lock() semaphore.
Context: process
Note1: netif_running() is guaranteed false
Note2: dev->poll() is guaranteed to be stopped
dev->do_ioctl:
Synchronization: rtnl_lock() semaphore.
Context: process
dev->get_stats:
Synchronization: dev_base_lock rwlock.
Context: nominally process, but don't sleep inside an rwlock
dev->hard_start_xmit:
Synchronization: dev->xmit_lock spinlock.
When the driver sets NETIF_F_LLTX in dev->features this will be
called without holding xmit_lock. In this case the driver
has to lock by itself when needed. It is recommended to use a try lock
for this and return -1 when the spin lock fails.
The locking there should also properly protect against
set_multicast_list
Context: BHs disabled
Notes: netif_queue_stopped() is guaranteed false
Interrupts must be enabled when calling hard_start_xmit.
(Interrupts must also be enabled when enabling the BH handler.)
Return codes:
o NETDEV_TX_OK everything ok.
o NETDEV_TX_BUSY Cannot transmit packet, try later
Usually a bug, means queue start/stop flow control is broken in
the driver. Note: the driver must NOT put the skb in its DMA ring.
o NETDEV_TX_LOCKED Locking failed, please retry quickly.
Only valid when NETIF_F_LLTX is set.
dev->tx_timeout:
Synchronization: dev->xmit_lock spinlock.
Context: BHs disabled
Notes: netif_queue_stopped() is guaranteed true
dev->set_multicast_list:
Synchronization: dev->xmit_lock spinlock.
Context: BHs disabled
dev->poll:
Synchronization: __LINK_STATE_RX_SCHED bit in dev->state. See
dev_close code and comments in net/core/dev.c for more info.
Context: softirq