swh:1:snp:c3bf2749e3476071fa748f67b0ffa2fdc5fe49d9
Tip revision: ff6992735ade75aae3e35d16b17da1008d753d28 authored by Linus Torvalds on 17 July 2022, 20:30:22 UTC
Linux 5.19-rc7
Linux 5.19-rc7
Tip revision: ff69927
via-core.h
/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* Copyright 1998-2009 VIA Technologies, Inc. All Rights Reserved.
* Copyright 2001-2008 S3 Graphics, Inc. All Rights Reserved.
* Copyright 2009-2010 Jonathan Corbet <corbet@lwn.net>
* Copyright 2010 Florian Tobias Schandinat <FlorianSchandinat@gmx.de>
*/
#ifndef __VIA_CORE_H__
#define __VIA_CORE_H__
#include <linux/types.h>
#include <linux/io.h>
#include <linux/spinlock.h>
#include <linux/pci.h>
/*
* A description of each known serial I2C/GPIO port.
*/
enum via_port_type {
VIA_PORT_NONE = 0,
VIA_PORT_I2C,
VIA_PORT_GPIO,
};
enum via_port_mode {
VIA_MODE_OFF = 0,
VIA_MODE_I2C, /* Used as I2C port */
VIA_MODE_GPIO, /* Two GPIO ports */
};
enum viafb_i2c_adap {
VIA_PORT_26 = 0,
VIA_PORT_31,
VIA_PORT_25,
VIA_PORT_2C,
VIA_PORT_3D,
};
#define VIAFB_NUM_PORTS 5
struct via_port_cfg {
enum via_port_type type;
enum via_port_mode mode;
u16 io_port;
u8 ioport_index;
};
/*
* Allow subdevs to register suspend/resume hooks.
*/
struct viafb_pm_hooks {
struct list_head list;
int (*suspend)(void *private);
int (*resume)(void *private);
void *private;
};
void viafb_pm_register(struct viafb_pm_hooks *hooks);
void viafb_pm_unregister(struct viafb_pm_hooks *hooks);
/*
* This is the global viafb "device" containing stuff needed by
* all subdevs.
*/
struct viafb_dev {
struct pci_dev *pdev;
int chip_type;
struct via_port_cfg *port_cfg;
/*
* Spinlock for access to device registers. Not yet
* globally used.
*/
spinlock_t reg_lock;
/*
* The framebuffer MMIO region. Little, if anything, touches
* this memory directly, and certainly nothing outside of the
* framebuffer device itself. We *do* have to be able to allocate
* chunks of this memory for other devices, though.
*/
unsigned long fbmem_start;
long fbmem_len;
void __iomem *fbmem;
#if defined(CONFIG_VIDEO_VIA_CAMERA) || defined(CONFIG_VIDEO_VIA_CAMERA_MODULE)
long camera_fbmem_offset;
long camera_fbmem_size;
#endif
/*
* The MMIO region for device registers.
*/
unsigned long engine_start;
unsigned long engine_len;
void __iomem *engine_mmio;
};
/*
* Interrupt management.
*/
void viafb_irq_enable(u32 mask);
void viafb_irq_disable(u32 mask);
/*
* The global interrupt control register and its bits.
*/
#define VDE_INTERRUPT 0x200 /* Video interrupt flags/masks */
#define VDE_I_DVISENSE 0x00000001 /* DVI sense int status */
#define VDE_I_VBLANK 0x00000002 /* Vertical blank status */
#define VDE_I_MCCFI 0x00000004 /* MCE compl. frame int status */
#define VDE_I_VSYNC 0x00000008 /* VGA VSYNC int status */
#define VDE_I_DMA0DDONE 0x00000010 /* DMA 0 descr done */
#define VDE_I_DMA0TDONE 0x00000020 /* DMA 0 transfer done */
#define VDE_I_DMA1DDONE 0x00000040 /* DMA 1 descr done */
#define VDE_I_DMA1TDONE 0x00000080 /* DMA 1 transfer done */
#define VDE_I_C1AV 0x00000100 /* Cap Eng 1 act vid end */
#define VDE_I_HQV0 0x00000200 /* First HQV engine */
#define VDE_I_HQV1 0x00000400 /* Second HQV engine */
#define VDE_I_HQV1EN 0x00000800 /* Second HQV engine enable */
#define VDE_I_C0AV 0x00001000 /* Cap Eng 0 act vid end */
#define VDE_I_C0VBI 0x00002000 /* Cap Eng 0 VBI end */
#define VDE_I_C1VBI 0x00004000 /* Cap Eng 1 VBI end */
#define VDE_I_VSYNC2 0x00008000 /* Sec. Disp. VSYNC */
#define VDE_I_DVISNSEN 0x00010000 /* DVI sense enable */
#define VDE_I_VSYNC2EN 0x00020000 /* Sec Disp VSYNC enable */
#define VDE_I_MCCFIEN 0x00040000 /* MC comp frame int mask enable */
#define VDE_I_VSYNCEN 0x00080000 /* VSYNC enable */
#define VDE_I_DMA0DDEN 0x00100000 /* DMA 0 descr done enable */
#define VDE_I_DMA0TDEN 0x00200000 /* DMA 0 trans done enable */
#define VDE_I_DMA1DDEN 0x00400000 /* DMA 1 descr done enable */
#define VDE_I_DMA1TDEN 0x00800000 /* DMA 1 trans done enable */
#define VDE_I_C1AVEN 0x01000000 /* cap 1 act vid end enable */
#define VDE_I_HQV0EN 0x02000000 /* First hqv engine enable */
#define VDE_I_C1VBIEN 0x04000000 /* Cap 1 VBI end enable */
#define VDE_I_LVDSSI 0x08000000 /* LVDS sense interrupt */
#define VDE_I_C0AVEN 0x10000000 /* Cap 0 act vid end enable */
#define VDE_I_C0VBIEN 0x20000000 /* Cap 0 VBI end enable */
#define VDE_I_LVDSSIEN 0x40000000 /* LVDS Sense enable */
#define VDE_I_ENABLE 0x80000000 /* Global interrupt enable */
#if defined(CONFIG_VIDEO_VIA_CAMERA) || defined(CONFIG_VIDEO_VIA_CAMERA_MODULE)
/*
* DMA management.
*/
int viafb_request_dma(void);
void viafb_release_dma(void);
/* void viafb_dma_copy_out(unsigned int offset, dma_addr_t paddr, int len); */
int viafb_dma_copy_out_sg(unsigned int offset, struct scatterlist *sg, int nsg);
/*
* DMA Controller registers.
*/
#define VDMA_MR0 0xe00 /* Mod reg 0 */
#define VDMA_MR_CHAIN 0x01 /* Chaining mode */
#define VDMA_MR_TDIE 0x02 /* Transfer done int enable */
#define VDMA_CSR0 0xe04 /* Control/status */
#define VDMA_C_ENABLE 0x01 /* DMA Enable */
#define VDMA_C_START 0x02 /* Start a transfer */
#define VDMA_C_ABORT 0x04 /* Abort a transfer */
#define VDMA_C_DONE 0x08 /* Transfer is done */
#define VDMA_MARL0 0xe20 /* Mem addr low */
#define VDMA_MARH0 0xe24 /* Mem addr high */
#define VDMA_DAR0 0xe28 /* Device address */
#define VDMA_DQWCR0 0xe2c /* Count (16-byte) */
#define VDMA_TMR0 0xe30 /* Tile mode reg */
#define VDMA_DPRL0 0xe34 /* Not sure */
#define VDMA_DPR_IN 0x08 /* Inbound transfer to FB */
#define VDMA_DPRH0 0xe38
#define VDMA_PMR0 (0xe00 + 0x134) /* Pitch mode */
/*
* Useful stuff that probably belongs somewhere global.
*/
#define VGA_WIDTH 640
#define VGA_HEIGHT 480
#endif /* CONFIG_VIDEO_VIA_CAMERA */
/*
* Indexed port operations. Note that these are all multi-op
* functions; every invocation will be racy if you're not holding
* reg_lock.
*/
#define VIAStatus 0x3DA /* Non-indexed port */
#define VIACR 0x3D4
#define VIASR 0x3C4
#define VIAGR 0x3CE
#define VIAAR 0x3C0
static inline u8 via_read_reg(u16 port, u8 index)
{
outb(index, port);
return inb(port + 1);
}
static inline void via_write_reg(u16 port, u8 index, u8 data)
{
outb(index, port);
outb(data, port + 1);
}
static inline void via_write_reg_mask(u16 port, u8 index, u8 data, u8 mask)
{
u8 old;
outb(index, port);
old = inb(port + 1);
outb((data & mask) | (old & ~mask), port + 1);
}
#define VIA_MISC_REG_READ 0x03CC
#define VIA_MISC_REG_WRITE 0x03C2
static inline void via_write_misc_reg_mask(u8 data, u8 mask)
{
u8 old = inb(VIA_MISC_REG_READ);
outb((data & mask) | (old & ~mask), VIA_MISC_REG_WRITE);
}
#endif /* __VIA_CORE_H__ */