Revision 1758bde2e4aa5ff188d53e7d9d388bbb7e12eebb authored by Lukas Wunner on 28 June 2022, 10:15:08 UTC, committed by Jakub Kicinski on 30 June 2022, 03:38:52 UTC
Upon system sleep, mdio_bus_phy_suspend() stops the phy_state_machine(), but subsequent interrupts may retrigger it: They may have been left enabled to facilitate wakeup and are not quiesced until the ->suspend_noirq() phase. Unwanted interrupts may hence occur between mdio_bus_phy_suspend() and dpm_suspend_noirq(), as well as between dpm_resume_noirq() and mdio_bus_phy_resume(). Retriggering the phy_state_machine() through an interrupt is not only undesirable for the reason given in mdio_bus_phy_suspend() (freezing it midway with phydev->lock held), but also because the PHY may be inaccessible after it's suspended: Accesses to USB-attached PHYs are blocked once usb_suspend_both() clears the can_submit flag and PHYs on PCI network cards may become inaccessible upon suspend as well. Amend phy_interrupt() to avoid triggering the state machine if the PHY is suspended. Signal wakeup instead if the attached net_device or its parent has been configured as a wakeup source. (Those conditions are identical to mdio_bus_phy_may_suspend().) Postpone handling of the interrupt until the PHY has resumed. Before stopping the phy_state_machine() in mdio_bus_phy_suspend(), wait for a concurrent phy_interrupt() to run to completion. That is necessary because phy_interrupt() may have checked the PHY's suspend status before the system sleep transition commenced and it may thus retrigger the state machine after it was stopped. Likewise, after re-enabling interrupt handling in mdio_bus_phy_resume(), wait for a concurrent phy_interrupt() to complete to ensure that interrupts which it postponed are properly rerun. The issue was exposed by commit 1ce8b37241ed ("usbnet: smsc95xx: Forward PHY interrupts to PHY driver to avoid polling"), but has existed since forever. Fixes: 541cd3ee00a4 ("phylib: Fix deadlock on resume") Link: https://lore.kernel.org/netdev/a5315a8a-32c2-962f-f696-de9a26d30091@samsung.com/ Reported-by: Marek Szyprowski <m.szyprowski@samsung.com> Tested-by: Marek Szyprowski <m.szyprowski@samsung.com> Signed-off-by: Lukas Wunner <lukas@wunner.de> Acked-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com> Cc: stable@vger.kernel.org # v2.6.33+ Reviewed-by: Andrew Lunn <andrew@lunn.ch> Link: https://lore.kernel.org/r/b7f386d04e9b5b0e2738f0125743e30676f309ef.1656410895.git.lukas@wunner.de Signed-off-by: Jakub Kicinski <kuba@kernel.org>
1 parent e65af54
File | Mode | Size |
---|---|---|
accessibility | ||
acpi | ||
amba | ||
android | ||
ata | ||
atm | ||
auxdisplay | ||
base | ||
bcma | ||
block | ||
bluetooth | ||
bus | ||
cdrom | ||
char | ||
clk | ||
clocksource | ||
comedi | ||
connector | ||
counter | ||
cpufreq | ||
cpuidle | ||
crypto | ||
cxl | ||
dax | ||
dca | ||
devfreq | ||
dio | ||
dma | ||
dma-buf | ||
edac | ||
eisa | ||
extcon | ||
firewire | ||
firmware | ||
fpga | ||
fsi | ||
gnss | ||
gpio | ||
gpu | ||
greybus | ||
hid | ||
hsi | ||
hte | ||
hv | ||
hwmon | ||
hwspinlock | ||
hwtracing | ||
i2c | ||
i3c | ||
idle | ||
iio | ||
infiniband | ||
input | ||
interconnect | ||
iommu | ||
ipack | ||
irqchip | ||
isdn | ||
leds | ||
macintosh | ||
mailbox | ||
mcb | ||
md | ||
media | ||
memory | ||
memstick | ||
message | ||
mfd | ||
misc | ||
mmc | ||
most | ||
mtd | ||
mux | ||
net | ||
nfc | ||
ntb | ||
nubus | ||
nvdimm | ||
nvme | ||
nvmem | ||
of | ||
opp | ||
parisc | ||
parport | ||
pci | ||
pcmcia | ||
peci | ||
perf | ||
phy | ||
pinctrl | ||
platform | ||
pnp | ||
power | ||
powercap | ||
pps | ||
ps3 | ||
ptp | ||
pwm | ||
rapidio | ||
ras | ||
regulator | ||
remoteproc | ||
reset | ||
rpmsg | ||
rtc | ||
s390 | ||
sbus | ||
scsi | ||
sh | ||
siox | ||
slimbus | ||
soc | ||
soundwire | ||
spi | ||
spmi | ||
ssb | ||
staging | ||
target | ||
tc | ||
tee | ||
thermal | ||
thunderbolt | ||
tty | ||
ufs | ||
uio | ||
usb | ||
vdpa | ||
vfio | ||
vhost | ||
video | ||
virt | ||
virtio | ||
vlynq | ||
vme | ||
w1 | ||
watchdog | ||
xen | ||
zorro | ||
Kconfig | -rw-r--r-- | 3.9 KB |
Makefile | -rw-r--r-- | 5.3 KB |
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...