Revision 2284bbd0cf3981462dc6d729c89851c66b05a66a authored by Leon Schuermann on 11 January 2021, 19:03:15 UTC, committed by Jakub Kicinski on 13 January 2021, 04:00:51 UTC
This commit enables the use of the r8153_ecm driver, introduced with commit c1aedf015ebdd0 ("net/usb/r8153_ecm: support ECM mode for RTL8153") for the Lenovo Powered USB-C Hub (17ef:721e) based on the Realtek RTL8153B chip. This results in the following driver preference: - if r8152 is available, use the r8152 driver - if r8152 is not available, use the r8153_ecm driver This is done to prevent the NIC from constantly sending pause frames when the host system enters standby (fixed by using the r8152 driver in "r8152: Add Lenovo Powered USB-C Travel Hub"), while still allowing the device to work with the r8153_ecm driver as a fallback. Signed-off-by: Leon Schuermann <leon@is.currently.online> Tested-by: Leon Schuermann <leon@is.currently.online> Link: https://lore.kernel.org/r/20210111190312.12589-3-leon@is.currently.online Signed-off-by: Jakub Kicinski <kuba@kernel.org>
1 parent cb82a54
File | Mode | Size |
---|---|---|
accessibility | ||
acpi | ||
amba | ||
android | ||
ata | ||
atm | ||
auxdisplay | ||
base | ||
bcma | ||
block | ||
bluetooth | ||
bus | ||
cdrom | ||
char | ||
clk | ||
clocksource | ||
connector | ||
counter | ||
cpufreq | ||
cpuidle | ||
crypto | ||
dax | ||
dca | ||
devfreq | ||
dio | ||
dma | ||
dma-buf | ||
edac | ||
eisa | ||
extcon | ||
firewire | ||
firmware | ||
fpga | ||
fsi | ||
gnss | ||
gpio | ||
gpu | ||
greybus | ||
hid | ||
hsi | ||
hv | ||
hwmon | ||
hwspinlock | ||
hwtracing | ||
i2c | ||
i3c | ||
ide | ||
idle | ||
iio | ||
infiniband | ||
input | ||
interconnect | ||
iommu | ||
ipack | ||
irqchip | ||
isdn | ||
leds | ||
lightnvm | ||
macintosh | ||
mailbox | ||
mcb | ||
md | ||
media | ||
memory | ||
memstick | ||
message | ||
mfd | ||
misc | ||
mmc | ||
most | ||
mtd | ||
mux | ||
net | ||
nfc | ||
ntb | ||
nubus | ||
nvdimm | ||
nvme | ||
nvmem | ||
of | ||
opp | ||
oprofile | ||
parisc | ||
parport | ||
pci | ||
pcmcia | ||
perf | ||
phy | ||
pinctrl | ||
platform | ||
pnp | ||
power | ||
powercap | ||
pps | ||
ps3 | ||
ptp | ||
pwm | ||
rapidio | ||
ras | ||
regulator | ||
remoteproc | ||
reset | ||
rpmsg | ||
rtc | ||
s390 | ||
sbus | ||
scsi | ||
sfi | ||
sh | ||
siox | ||
slimbus | ||
soc | ||
soundwire | ||
spi | ||
spmi | ||
ssb | ||
staging | ||
target | ||
tc | ||
tee | ||
thermal | ||
thunderbolt | ||
tty | ||
uio | ||
usb | ||
vdpa | ||
vfio | ||
vhost | ||
video | ||
virt | ||
virtio | ||
visorbus | ||
vlynq | ||
vme | ||
w1 | ||
watchdog | ||
xen | ||
zorro | ||
Kconfig | -rw-r--r-- | 3.8 KB |
Makefile | -rw-r--r-- | 5.3 KB |
Computing file changes ...