Revision 4b79f0af48d529a360d3529def01835dc5d45fe1 authored by Ian McDonald on 24 July 2006, 06:33:28 UTC, committed by David S. Miller on 24 July 2006, 19:44:21 UTC
When using the default sequence window size (100) I got the following in my logs: Jun 22 14:24:09 localhost kernel: [ 1492.114775] DCCP: Step 6 failed for DATA packet, (LSWL(6279674225) <= P.seqno(6279674749) <= S.SWH(6279674324)) and (P.ackno doesn't exist or LAWL(18798206530) <= P.ackno(1125899906842620) <= S.AWH(18798206548), sending SYNC... Jun 22 14:24:09 localhost kernel: [ 1492.115147] DCCP: Step 6 failed for DATA packet, (LSWL(6279674225) <= P.seqno(6279674750) <= S.SWH(6279674324)) and (P.ackno doesn't exist or LAWL(18798206530) <= P.ackno(1125899906842620) <= S.AWH(18798206549), sending SYNC... I went to alter the default sysctl and it didn't take for new sockets. Below patch fixes this. I think the default is too low but it is what the DCCP spec specifies. As a side effect of this my rx speed using iperf goes from about 2.8 Mbits/sec to 3.5. This is still far too slow but it is a step in the right direction. Compile tested only for IPv6 but not particularly complex change. Signed off by: Ian McDonald <ian.mcdonald@jandi.co.nz> Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com> Signed-off-by: David S. Miller <davem@davemloft.net>
1 parent 8fdf679
File | Mode | Size |
---|---|---|
acorn | ||
acpi | ||
amba | ||
atm | ||
base | ||
block | ||
bluetooth | ||
cdrom | ||
char | ||
clocksource | ||
connector | ||
cpufreq | ||
crypto | ||
dio | ||
dma | ||
edac | ||
eisa | ||
fc4 | ||
firmware | ||
hwmon | ||
i2c | ||
ide | ||
ieee1394 | ||
infiniband | ||
input | ||
isdn | ||
leds | ||
macintosh | ||
mca | ||
md | ||
media | ||
message | ||
mfd | ||
misc | ||
mmc | ||
mtd | ||
net | ||
nubus | ||
oprofile | ||
parisc | ||
parport | ||
pci | ||
pcmcia | ||
pnp | ||
rapidio | ||
rtc | ||
s390 | ||
sbus | ||
scsi | ||
serial | ||
sh | ||
sn | ||
spi | ||
tc | ||
telephony | ||
usb | ||
video | ||
w1 | ||
zorro | ||
Kconfig | -rw-r--r-- | 1.2 KB |
Makefile | -rw-r--r-- | 2.3 KB |
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...