Revision 7ba1b689038726d34e3244c1ac9e2e18c2ea4787 authored by Ralf Baechle on 09 February 2017, 13:12:11 UTC, committed by David S. Miller on 10 February 2017, 18:41:13 UTC
If a USB-to-serial adapter is unplugged, the driver re-initializes, with dev->hard_header_len and dev->addr_len set to zero, instead of the correct values. If then a packet is sent through the half-dead interface, the kernel will panic due to running out of headroom in the skb when pushing for the AX.25 headers resulting in this panic: [<c0595468>] (skb_panic) from [<c0401f70>] (skb_push+0x4c/0x50) [<c0401f70>] (skb_push) from [<bf0bdad4>] (ax25_hard_header+0x34/0xf4 [ax25]) [<bf0bdad4>] (ax25_hard_header [ax25]) from [<bf0d05d4>] (ax_header+0x38/0x40 [mkiss]) [<bf0d05d4>] (ax_header [mkiss]) from [<c041b584>] (neigh_compat_output+0x8c/0xd8) [<c041b584>] (neigh_compat_output) from [<c043e7a8>] (ip_finish_output+0x2a0/0x914) [<c043e7a8>] (ip_finish_output) from [<c043f948>] (ip_output+0xd8/0xf0) [<c043f948>] (ip_output) from [<c043f04c>] (ip_local_out_sk+0x44/0x48) This patch makes mkiss behave like the 6pack driver. 6pack does not panic. In 6pack.c sp_setup() (same function name here) the values for dev->hard_header_len and dev->addr_len are set to the same values as in my mkiss patch. [ralf@linux-mips.org: Massages original submission to conform to the usual standards for patch submissions.] Signed-off-by: Thomas Osterried <thomas@osterried.de> Signed-off-by: Ralf Baechle <ralf@linux-mips.org> Signed-off-by: David S. Miller <davem@davemloft.net>
1 parent b85ea00
File | Mode | Size |
---|---|---|
accessibility | ||
acpi | ||
amba | ||
android | ||
ata | ||
atm | ||
auxdisplay | ||
base | ||
bcma | ||
block | ||
bluetooth | ||
bus | ||
cdrom | ||
char | ||
clk | ||
clocksource | ||
connector | ||
cpufreq | ||
cpuidle | ||
crypto | ||
dax | ||
dca | ||
devfreq | ||
dio | ||
dma | ||
dma-buf | ||
edac | ||
eisa | ||
extcon | ||
firewire | ||
firmware | ||
fmc | ||
fpga | ||
gpio | ||
gpu | ||
hid | ||
hsi | ||
hv | ||
hwmon | ||
hwspinlock | ||
hwtracing | ||
i2c | ||
ide | ||
idle | ||
iio | ||
infiniband | ||
input | ||
iommu | ||
ipack | ||
irqchip | ||
isdn | ||
leds | ||
lguest | ||
lightnvm | ||
macintosh | ||
mailbox | ||
mcb | ||
md | ||
media | ||
memory | ||
memstick | ||
message | ||
mfd | ||
misc | ||
mmc | ||
mtd | ||
net | ||
nfc | ||
ntb | ||
nubus | ||
nvdimm | ||
nvme | ||
nvmem | ||
of | ||
oprofile | ||
parisc | ||
parport | ||
pci | ||
pcmcia | ||
perf | ||
phy | ||
pinctrl | ||
platform | ||
pnp | ||
power | ||
powercap | ||
pps | ||
ps3 | ||
ptp | ||
pwm | ||
rapidio | ||
ras | ||
regulator | ||
remoteproc | ||
reset | ||
rpmsg | ||
rtc | ||
s390 | ||
sbus | ||
scsi | ||
sfi | ||
sh | ||
sn | ||
soc | ||
spi | ||
spmi | ||
ssb | ||
staging | ||
target | ||
tc | ||
thermal | ||
thunderbolt | ||
tty | ||
uio | ||
usb | ||
uwb | ||
vfio | ||
vhost | ||
video | ||
virt | ||
virtio | ||
vlynq | ||
vme | ||
w1 | ||
watchdog | ||
xen | ||
zorro | ||
Kconfig | -rw-r--r-- | 3.3 KB |
Makefile | -rw-r--r-- | 4.9 KB |
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...