Revision 9f28ffc03e93343ac04874fda9edb7affea45165 authored by David S. Miller on 19 December 2012, 23:19:11 UTC, committed by David S. Miller on 19 December 2012, 23:19:11 UTC
The basic scheme of the block mode assembler is that we start by enabling the FPU, loading the key into the floating point registers, then iterate calling the encrypt/decrypt routine for each block. For the 256-bit key cases, we run short on registers in the unrolled loops. So the {ENCRYPT,DECRYPT}_256_2() macros reload the key registers that get clobbered. The unrolled macros, {ENCRYPT,DECRYPT}_256(), are not mindful of this. So if we have a mix of multi-block and single-block calls, the single-block unrolled 256-bit encrypt/decrypt can run with some of the key registers clobbered. Handle this by always explicitly loading those registers before using the non-unrolled 256-bit macro. This was discovered thanks to all of the new test cases added by Jussi Kivilinna. Signed-off-by: David S. Miller <davem@davemloft.net>
1 parent 4a9d194
File | Mode | Size |
---|---|---|
accessibility | ||
acpi | ||
amba | ||
ata | ||
atm | ||
auxdisplay | ||
base | ||
bcma | ||
block | ||
bluetooth | ||
bus | ||
cdrom | ||
char | ||
clk | ||
clocksource | ||
connector | ||
cpufreq | ||
cpuidle | ||
crypto | ||
dca | ||
devfreq | ||
dio | ||
dma | ||
edac | ||
eisa | ||
extcon | ||
firewire | ||
firmware | ||
gpio | ||
gpu | ||
hid | ||
hsi | ||
hv | ||
hwmon | ||
hwspinlock | ||
i2c | ||
ide | ||
idle | ||
iio | ||
infiniband | ||
input | ||
iommu | ||
ipack | ||
irqchip | ||
isdn | ||
leds | ||
lguest | ||
macintosh | ||
md | ||
media | ||
memory | ||
memstick | ||
message | ||
mfd | ||
misc | ||
mmc | ||
mtd | ||
net | ||
nfc | ||
nubus | ||
of | ||
oprofile | ||
parisc | ||
parport | ||
pci | ||
pcmcia | ||
pinctrl | ||
platform | ||
pnp | ||
power | ||
pps | ||
ps3 | ||
ptp | ||
pwm | ||
rapidio | ||
regulator | ||
remoteproc | ||
rpmsg | ||
rtc | ||
s390 | ||
sbus | ||
scsi | ||
sfi | ||
sh | ||
sn | ||
spi | ||
ssb | ||
staging | ||
target | ||
tc | ||
thermal | ||
tty | ||
uio | ||
usb | ||
uwb | ||
vfio | ||
vhost | ||
video | ||
virt | ||
virtio | ||
vlynq | ||
vme | ||
w1 | ||
watchdog | ||
xen | ||
zorro | ||
Kconfig | -rw-r--r-- | 2.6 KB |
Makefile | -rw-r--r-- | 4.1 KB |
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...