Revision bd13b2b874eceb4677cd26eebdc5f45cc52fa400 authored by Nicholas Kazlauskas on 01 February 2019, 14:36:59 UTC, committed by Alex Deucher on 08 April 2019, 15:33:40 UTC
[Why] If the cursor pos passed from DM is less than the plane_state->dst_rect top left corner then the unsigned cursor pos wraps around to a large positive number since cursor pos is a u32. There was an attempt to guard against this in hubp1_cursor_set_position by checking the src_x_offset and src_y_offset and offseting the cursor hotspot within hubp1_cursor_set_position. However, the cursor position itself is still being programmed incorrectly as a large value. This manifests itself visually as the cursor disappearing or containing strange artifacts near the middle of the screen on raven. [How] Don't subtract the destination rect top left corner from the pos but add it to the hotspot instead. This happens before the pos gets passed into hubp1_cursor_set_position. This achieves the same result but avoids the subtraction wrap around. With this fix the original cursor programming logic can be used again. v2: add hunk that got dropped accidently when this patch was originally committed. (Alex) Fixes: 0921c41e1902831 ("drm/amd/display: Fix negative cursor pos programming") Signed-off-by: Nicholas Kazlauskas <nicholas.kazlauskas@amd.com> Reviewed-by: Charlene Liu <Charlene.Liu@amd.com> Acked-by: Leo Li <sunpeng.li@amd.com> Acked-by: Murton Liu <Murton.Liu@amd.com> Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
1 parent c1cefe1
File | Mode | Size |
---|---|---|
accessibility | ||
acpi | ||
amba | ||
android | ||
ata | ||
atm | ||
auxdisplay | ||
base | ||
bcma | ||
block | ||
bluetooth | ||
bus | ||
cdrom | ||
char | ||
clk | ||
clocksource | ||
connector | ||
cpufreq | ||
cpuidle | ||
crypto | ||
dax | ||
dca | ||
devfreq | ||
dio | ||
dma | ||
dma-buf | ||
edac | ||
eisa | ||
extcon | ||
firewire | ||
firmware | ||
fmc | ||
fpga | ||
fsi | ||
gnss | ||
gpio | ||
gpu | ||
hid | ||
hsi | ||
hv | ||
hwmon | ||
hwspinlock | ||
hwtracing | ||
i2c | ||
i3c | ||
ide | ||
idle | ||
iio | ||
infiniband | ||
input | ||
interconnect | ||
iommu | ||
ipack | ||
irqchip | ||
isdn | ||
leds | ||
lightnvm | ||
macintosh | ||
mailbox | ||
mcb | ||
md | ||
media | ||
memory | ||
memstick | ||
message | ||
mfd | ||
misc | ||
mmc | ||
mtd | ||
mux | ||
net | ||
nfc | ||
ntb | ||
nubus | ||
nvdimm | ||
nvme | ||
nvmem | ||
of | ||
opp | ||
oprofile | ||
parisc | ||
parport | ||
pci | ||
pcmcia | ||
perf | ||
phy | ||
pinctrl | ||
platform | ||
pnp | ||
power | ||
powercap | ||
pps | ||
ps3 | ||
ptp | ||
pwm | ||
rapidio | ||
ras | ||
regulator | ||
remoteproc | ||
reset | ||
rpmsg | ||
rtc | ||
s390 | ||
sbus | ||
scsi | ||
sfi | ||
sh | ||
siox | ||
slimbus | ||
sn | ||
soc | ||
soundwire | ||
spi | ||
spmi | ||
ssb | ||
staging | ||
target | ||
tc | ||
tee | ||
thermal | ||
thunderbolt | ||
tty | ||
uio | ||
usb | ||
uwb | ||
vfio | ||
vhost | ||
video | ||
virt | ||
virtio | ||
visorbus | ||
vlynq | ||
vme | ||
w1 | ||
watchdog | ||
xen | ||
zorro | ||
Kconfig | -rw-r--r-- | 3.7 KB |
Makefile | -rw-r--r-- | 5.3 KB |
![swh spinner](/static/img/swh-spinner.gif)
Computing file changes ...